PDF user manual for CopperEdge 150

5. Verify that the save was successful:CRAFT> get cmsystemGroup: cmSystemObjectClass= SystemOperState= EnabledVersion = E 3.0Master = 0.0.0.0ConfigFileName = config.tgzCalendarTime = 2000/07/21-10:01:11MyPII = 1.2.0.0PrimaryPII = 1.2.0.0SecondaryPII = 0.0.0.0Redundancy= NotAvailableShelfCount = 1ExpIpSubNet = 192.168.250.0ConfigSynch= SavedCommand= SaveConfigCommandStatus = Succeeded6. If the CommandStatus object displays InProgressinstead of Succeeded, repeat the get cmsystemcommand.If it displays Failed, contact Copper MountainTechnical Support.7. Log out of the CE150.8SJUDGHWKH6RIWZDUHRQWKH&(Rename the Current and Backup Directories1. Initiate an FTP session to the CE150 and log in.C:\>ftp DSLAM_IpAddressConnected to DSLAM_IpAddressUser 2. Enter admin when you are asked for the user name andpassword.3. Check the current directory structure:ftp> dir200 Port set okay150 Opening ASCII mode data connectionsize date time name-------- ------ ------ --------512 Nov-09-2099 12:08:08 CE200 512 Nov-09-2099 12:08:08 CE200- 1024 bytes. 1248768 bytes free.226 Transfer complete252 bytes received in 0.00 seconds Note that two directories are listed with similar names:ce200 and ce200- (“ce200 minus”). The ce200-directory contains the code and supporting files for thelast version of the software that ran on this CE150before the version currently installed.If the CE150 is unable to boot from its current software(contained in the ce200 directory), it automaticallylooks for the ce200- directory and tries to boot usingthe previous software version.$SSHQGL['8SJUDGLQJ6\VWHP6RIWZDUH