PDF user manual for CopperEdge 150

6\VWHP&ORFNCheck the system clock and observe the date and time displayedin the format shown (time in 24-hour format) in the example:CRAFT> get cmsystem calendartimeCalendarTime = 2000/06/15-12:04:17If necessary, set the clock to the correct date and time:CRAFT> set cmsystem calendartime=2000/06/15-15:05:00Set SuccessfulVerify that the clock displays the correct date and time:CRAFT> get cmsystem calendartimeCalendarTime = 2000/06/15-15:05:097UDS'HVWLQDWLRQConfigure at least one trap destination (a managing device towhich SNMP traps should be sent).CRAFT> set cmtrapdest [n.n.n.n, 162] community=trapcommrowstatus=activewhere n.n.n.n is the IP address of the SNMP manager.Depending on the SNMP manager you are using, it may also benecessary to configure an IP port number or a communitystring for the receiver. For more information, see the descriptionof the cmTrapDestination group in the CopperEdge 150CopperCraft Reference and MIB Definitions manual.&RQILJXULQJWKH&(RQWKH1HWZRUNTo communicate over the network with a remote host or to setup a server to connect to the CE150 through Telnet or FTP, youmust enable one of the system’s network interfaces. It may bethe Ethernet interface (1.2.1), one of the WAN interfaces in slots3 or 4, or a DSL port.1. Configure the network interface to be used for controland management of the system with an IP address andmask:CRAFT> set cmiface [1.3.1] netmodel=ipipaddr=204.16.191.254 netmask=255.255.255.0encapsulationtype=none2. If this interface will use a NetModel/ForwardingModeother than Full IP, specify those options as necessary.3. Note also that if the network interface is a Frame Relayor ATM virtual circuit, you must also specify the DLCIor ATM Virtual Link number in the PII:CRAFT> set cmiface [1.2.1.23]farendaddr=202.114.66.188 netmodel=vwanencapsulationtype=rfc1490&KDSWHU,QLWLDO&RQILJXUDWLRQ