PDF user manual for CopperEdge 150

5. The example here is a simplified one that does notspecify LMI. To provide a link with LMI, use the Stateobject in the standard frDlcmi group to specify the LMIformatting scheme. For more information on FrameRelay configuration, including LMI, see Chapter 6.6. Activate the virtual circuit.CRAFT> set frcircuit [1.2.1.27] state=activeSet Successful7. Repeat step 1 for each port to be included in the VirtualBridge group.8. Optional: Configure the Virtual Bridge to blockbroadcast packets (such as IPX) to the wide areanetwork.CRAFT> set cmvbridge [1.2.1.27] option=ip-specialSet Successful9. For more about cmVbridge, see the CopperEdge 150CopperCraft Reference and MIB Definitions manual.10. When you have completed the initial configuration ofthe CE150 and its interfaces, save the configurationdata:CRAFT> set cmsystem command = save11. The file is saved on the appropriate volume (P:) as:\ce200\system\config.tgz (or config.txt). For moreinformation, see Saving Values on page 108.12. At the far end of the VWAN link (the main LAN site)configure the IRB-capable router to provide a bridgevirtual interface (BVI).13. For example, here is a typical config.txt file for a CiscoSystems IRB-capable router showing the relevantentries for VWAN (in this example, the DLCI number is30):!interface Ethernet0ip address 192.1.1.188 255.255.255.0!interface Serial0no ip addressencapsulation frame-relay IETFno keepaliveignore-dcd!interface Serial0.1 point-to-pointframe-relay interface-dlci 30bridge-group 1!interface Serial1no ip addressshutdown!interface BVI1mac-address 0000.0c00.338cip address 206.41.72.1 255.255.255.0no keepalive!bridge irbbridge 1 protocol ieeebridge 1 route ip!14. For additional information, please consult thedocumentation supplied by the manufacturer.&KDSWHU$GYDQFHG&RQILJXUDWLRQ