PDF user manual for CopperEdge 150

Ethernet PortConnect a Category 5 STP cable (with RJ-45 connectors at bothends) between the Net 1 connector, and any available port10BASE-T or 100BASE-T) of a network facility, such as a hub.The Net 2 connector for Ethernet 2 is not supported in this release.1 Tx Data +2 Tx Data -3 Rx Data +6 Rx Data -Ethernet Port PinoutsCraft and Diagnostic Serial PortsBoth the Craft and Diagnostic ports are 16C550 PC-Compatibleserial ports with RJ-45 connectors. Unlike the SCM-1 andSCM-2 boards, you can concurrently use the Craft and Modemports on the SCM-3 board.1 Request To Send (RTS)2 Data Terminal Ready (DTR)3 Transmitted Data (TXD)4 Ground (GND)5 Ground (GND)6 Receive Data (RXD)7 Data Set Ready (DSR)8 Clear To Send (CTS)Straight-through Pinouts for the Craft andDiagnostic PortsIf you are using an access server, connect a Category 5 STP rollovercable (with RJ-45 connectors at both ends) between theCOM port on the server and the Craft port on the CE150.If you are using a local terminal or computer, attach a Category5 STP cable (with RJ-45 connectors at both ends) between theCOM port on the local terminal or computer and the Craft porton the CE150. Refer to the following table for the pinouts.&KDSWHU,QVWDOODWLRQ