PDF user manual for CopperEdge 150

3. Set the VC on the DSL port. Use a PII such as 1.4.1.23and specify a VPI and VCI. They must match the ones onthe CPE. Typically, they are 0 and 32. Documentationfor CPEs will give defaults, indicate if they can bechanged, and show when multiple VCs are possible. Thenumber of the VC must be in the range of 16 to 23.CRAFT> set cmatmvcl [1.4.1.23] vpi=0 vci=32adminstatus=upPerform a Get on the VC and you will see this table:CRAFT> get cmatmvcl [1.4.1.23]Group: cmAtmVclTableInstance: [1.4.1.23]PII = 1.4.1.23Vpi = 0Vci = 32AdminStatus= UpOperStatus= UpLastChange= 0 day 0 hour 0 min 0.0 sec(1999/12/23-08:03:37)AalType= Aal5Aal5CpcsTransmitSduS = 1600Aal5CpcsReceiveSduSi = 1600RowStatus= ActiveTransmitTrafficDescr = 1OAMState= adminDown(0)OAMAdminState = disabledOAMAutoLBState = disabledOAMManualLBCmd = noneOAMManualLBCmdStatus = noneOAMLBInterval = 5OAMLBTimeOut = 15OAMTxAISCells = 0OAMRxRDICells = 0OAMRxAISCells = 0OAMTxRDICells = 0OAMTxLBRequestCells = 0OAMRxLBResponseCells = 0OAMRxLBRequestCells = 0OAMTxLBResponseCells = 0OAMRxUnsupportedCell = 0OAMTxDiscards = 0OAMRxDiscards = 04. Set the NetModel and the EncapsulationType for theDSL port. Use the same PII, 1.4.1, that you used instep 3. The VC number is not necessary. Set CMCP toNo (the default is Yes).CRAFT> set cmiface [1.4.1] netmodel=cross-connectencapsulationtype=atm cmcpcompatible=noPerform a Get on the port and look at the table:CRAFT> get cmiface [1.4.1]Group: cmIfaceTableInstance: [1.4.1.0]PII = 1.4.1.0IfIndex = 1.4.1.0Name = ""GroupName = ""AdditionalInfo = ""NetModel= Cross-ConnectIpAddr = 0.0.0.0NetMask = 0.0.0.0MacAddr= ff.ff.ff.ff.ff.ffBurnedInMacAddr = 0.0.0.0.0.0FarEndAddr = 0.0.0.0DestPII = 0.0.0.0CMCPCompatible = NoEncapsulationType = atmFwdMode= PER-VCPix = 3ServiceClass= D&RSSHU(GJH,QVWDOODWLRQDQG2SHUDWLQJ*XLGH