PDF user manual for CopperEdge 150

6DYLQJ9DOXHVHere are the proprietary system values for the following configurableobjects:CalendarTimeRedundancyCommandSet or display the system real time clock(date and time set at initial configuration)Enables or Disables redundancy functionality.When Enabled, the secondaryControl and WAN complex can take overas primary. This is not available on theCE150.The command get cmsystem responds withthe last operator command.Use the command set cmsystem to savethe Config (configuration) file and to restartthe system.When you have finished adjusting the system attributes to yourpreferred settings, save the configuration data:CRAFT> set cmsystem command=saveThe data is saved to the appropriate volume (P:) in flash as:\ce200\system\config.tgz (or config.txt).To verify that the save command was successful:CRAFT> get cmsystemGroup: cmSystemObjectClass= SystemOperState= EnabledVersion = E 3.0Master = 0.0.0.0ConfigFileName = config.tgzCalendarTime = 2000/07/21-10:01:11MyPII = 1.2.0.0PrimaryPII = 1.2.0.0SecondaryPII = 0.0.0.0Redundancy= NotAvailableShelfCount = 1ExpIpSubNet = 192.168.250.0ConfigSynch= SavedCommand= SaveConfigCommandStatus = SucceededIn the resulting cmSystem listing, the CommandStatus fieldshould indicate Succeeded. If Command Status shows In-Progress, repeat the command get cmsystem; if Command Statusshows Failed, contact Copper Mountain Tech Support.1 2 7 (The cmSystem readConfig command is not supported in this release.If it becomes necessary to reload a previous configuration, use thecmMaintCmd group’s ConfigRestore command. (See Restoring aBacked Up Configuration on page 111).&RSSHU(GJH,QVWDOODWLRQDQG2SHUDWLQJ*XLGH