PDF user manual for CopperEdge 150

For the first PPP connection on the DSL port, follow these steps:1. Set the VC on the WAN port. The VPI and VCI on theWAN VC must match the ones on the Telco router, butthe VCL does not have to match its counterpart on theTelco router. Set AdminStatus to Up.CRAFT> set cmatmvcl [1.2.1.130] vpi=1 vci=121adminstatus=upPerform a Get on the VC and you will see this table:CRAFT> get cmatmvcl [1.2.1.130]Group: cmAtmVclTableInstance: [1.2.1.130]PII = 1.2.1.130Vpi = 1Vci = 121AdminStatus= UpOperStatus= UpLastChange= 0 day 0 hour 0 min 0.0 sec(1999/12/23-04:03:39)AalType= Aal5Aal5CpcsTransmitSduS = 1600Aal5CpcsReceiveSduSi = 1600RowStatus= ActiveTransmitTrafficDescr = 1OAMState= adminDown(0)OAMAdminState = disabledOAMAutoLBState = disabledOAMManualLBCmd = noneOAMManualLBCmdStatus = noneOAMLBInterval = 5OAMLBTimeOut = 15OAMTxAISCells = 0OAMRxRDICells = 0OAMRxAISCells = 0OAMTxRDICells = 0OAMTxLBRequestCells = 0OAMRxLBResponseCells = 0OAMRxLBRequestCells = 0OAMTxLBResponseCells = 0OAMRxUnsupportedCell = 0OAMTxDiscards = 0OAMRxDiscards = 02. Set the NetModel and the EncapsulationType for theWAN VC. The NetModel must be Cross-Connect. TheEncapsulationType must be None.CRAFT> set cmiface [1.2.1.130] netmodel=crossconnectencapsulationtype=nonePerform a Get on the VC and you will see this table:CRAFT> get cmiface [1.2.1.130]Group: cmIfaceTableInstance: [1.2.1.130]PII = 1.2.1.130IfIndex = 1.2.1.130Name = ""GroupName = ""AdditionalInfo = ""NetModel= Cross-ConnectIpAddr = 0.0.0.0NetMask = 0.0.0.0MacAddr= ff.ff.ff.ff.ff.ffBurnedInMacAddr = ff.ff.ff.ff.ff.ffFarEndAddr = 0.0.0.0DestPII = 0.0.0.0CMCPCompatible = NoEncapsulationType = NoneFwdMode= VC-VC-payloadPix = 274ServiceClass= None&KDSWHU$'6/*OLWHDQG*GPW