PDF user manual for CopperEdge 150

1. Set the VC on the WAN port. The VPI and VCI on theWAN VC must match those on the Telco router. SetAdminStatus to Up (the default is Down).CRAFT> set cmatmvcl [1.2.1.80] vpi=1 vci=122adminstatus=upPerform a Get on the VC and you will see this table:CRAFT> get cmatmvcl [1.2.1.80]Group: cmAtmVclTableInstance: [1.2.1.80]PII = 1.2.1.80Vpi = 1Vci = 122AdminStatus= UpOperStatus= UpLastChange= 0 day 0 hour 0 min 0.0 sec(2000)04/14-14:41:37)AalType= Aal5Aal5CpcsTransmitSduS = 1600Aal5CpcsReceiveSduSi = 1600RowStatus= ActiveTransmitTrafficDescr = 1OAMState= adminDown(0)OAMAdminState = disabledOAMAutoLBState = disabledOAMManualLBCmd = noneOAMManualLBCmdStatus = noneOAMLBInterval = 5OAMLBTimeOut = 15OAMTxAISCells = 0OAMRxRDICells = 0OAMRxAISCells = 0OAMTxRDICells = 0OAMTxLBRequestCells = 0OAMRxLBResponseCells = 0OAMRxLBRequestCells = 0OAMTxLBResponseCells = 0OAMRxUnsupportedCell = 0OAMTxDiscards = 0OAMRxDiscards = 02. Set NetModel, IPAddr, NetMask, and Encapsulation-Type for the WAN port and the FarEndAddr. TheNetModel must be IP. The EncapsulationType must berfc1483.CRAFT> set cmiface [1.2.1.80] netmodel=ipipaddr=192.168.20.2 netmask=255.255.255.255farendaddr=192.168.20.1 encapsulationtype=rfc1483Perform a Get on the VC and you will see this table:CRAFT> get cmiface [1.2.1.80]Group: cmIfaceTableInstance: [1.2.1.80]PII = 1.2.1.80IfIndex = 1.2.1.80Name = ""GroupName = ""AdditionalInfo = ""NetModel= IPIpAddr = 192.168.20.2NetMask = 255.255.255.255MacAddr= ff.ff.ff.ff.ff.ffBurnedInMacAddr = ff.ff.ff.ff.ff.ffFarEndAddr = 192.168.10.1DestPII = 0.0.0.0CMCPCompatible = NoEncapsulationType = rfc1483FwdMode= Full-IPPix = 28ServiceClass= None&KDSWHU$'6/*OLWHDQG*GPW