PDF user manual for CopperEdge 150

&RSSHU&UDIW/LQH(GLWRUCommand strings for SNMP object groups can be very short orvery long, especially when you are setting a series of new parametersin an object group. Here is an example of a short getallcommand, which returns data about all of the boards in theCE150’s chassis:CRAFT> getall cmboardHere is an example of a longer Set command, which sets the parameterson an ATM quality of service table:CRAFT> set cmcircuitparam [6] rowstatus=createandgoservicecategory=nrtvbr pcr=104000 scr=604 mbs=4cdv=unspecifiedThe line editor function on the CopperCraft CLI lets you recallas many as 20 previous commands from the system’s memorybuffer. You can move through the command lines and edit thembefore you press Enter and send the command to the system.To display the list of valid Line Editor commands, press esc-?at the system prompt.CRAFT>^DDelete current characterDELDelete current character^HBackspace^EEnd of line^ABeginning of lineEscape F Forward one wordEscape B Backward one word^KDelete to end of line^UDelete to beginning of line^U^KDelete entire line^LRedisplay current lineLeft Arrow Cursor leftRight Arrow Cursor rightUp Arrow Scroll up through history^PScroll up through historyDown Arrow Scroll down through history^NScroll down through historyControl characters are shown with a caret (^). Press and holdthe Control key, press the letter key, then release both keys.Escape sequences are indicated by the word, Escape. Press andrelease the Escape key, and then press the letter key.If you are using a terminal emulator, be sure to set it to VT100mode. If a command line will not fit on a single line, an arrowcharacter (< or >) appears at either end of the line indicatingScroll mode. Use the arrow keys to move to the end of the line;the next 10 characters will be displayed.&RSSHU(GJH,QVWDOODWLRQDQG2SHUDWLQJ*XLGH