PDF user manual for CopperEdge 150

12. Perform a Get on the IAD (CPE:1.4.13) attached to thefirst DSL port. See if the CurrentIPAddr andSavedIpAddr and the CurrentCAIpAddr andSavedCAIpAddr are zeros or non-zeros. If they are zerosas shown in the following example, go to step 14.CRAFT> get cmcpeiad [cpe:1.4.13]Group: cmCpeIADTableInstance: [CPE:1.4.13]Index= CPE:1.4.13CurrentIpAddr = 0.0.0.0CurrentCAIpAddr = 0.0.0.0SavedIpAddr = 0.0.0.0SavedCAIpAddr = 0.0.0.0NumVoicePorts = 0NumConnections = 0Command= NoneTOSByte = 0LogAction= NoneLogType= ALL(0)LogLevel= INFO(0)LogDuration = 30TotalMsgsLogged = 0Trace1Mask = 0Trace2Mask = 0If the IP addresses are already set and they aredifferent from the ones set in steps 5 to 9, go to step 13.CRAFT> get cmcpeiad [cpe:1.4.13]Group: cmCpeIADTableInstance: [CPE:1.4.13]Index= CPE:1.4.13CurrentIpAddr = 10.0.45.2CurrentCAIpAddr = 10.0.45.1SavedIpAddr = 10.0.45.2SavedCAIpAddr = 10.0.45.1NumVoicePorts = 8NumConnections = 8Command= NoneTOSByte = 0LogAction= NoneLogType= ALL(0)LogLevel= INFO(0)LogDuration = 30TotalMsgsLogged = 0Trace1Mask = 0Trace2Mask = 0IAD Without Saved IP Addresses in NVRAMNot on Subnet 10.0.21.08PhonesIADHDIADSLAMIP Addr: 10.0.21.1VoiceGatewayIAD With Saved IP Addresses in NVRAMNot on Subnet 10.0.21.0IAD8Phones IP Addr: 10.0.45.2HDIADSLAMIP Addr: 10.0.21.1VoiceGatewayHDIA Netmodel—Configuring the IP Address on the CR408&KDSWHU9RLFHRYHU'6/