PDF user manual for CopperEdge 150

When many DSL links comprise a virtual bridge group, the cmIfaceFwdMode object is VWAN BRIDGED. When only a singleDSL link comprises a bridge group, the FwdMode object in thecmIface group is VWAN POINT-TO-POINT. When the Ethernetport is configured as the destination WAN interface, the Fwd-Mode object is always VWAN BRIDGED, even for a single membergroup.Configuration of VWAN links must be coordinated with the telecom/datacommanagement at the far end of the upstream link.An IRB-capable router with a compatible operating system(IOS) version must be installed at the far end.The following procedure provides a model for end-to-end configurationof an SDSL subscriber for VWAN, using a Frame RelayWAN link. Configuration of the network port for VWAN overEthernet appears in Chapter 5.1. Configure the DSL interface for VWAN and specify theoutbound facility to use.2. Remember that, for a Frame Relay or ATM WANinterface, the DESTPII object includes the number(Frame Relay DLCI or ATM Virtual Link) that identifiesthe associated virtual circuit. For example:CRAFT> set cmiface [1.4.1] netmodel=vwanencapsulationtype=rfc1483 destpii=1.2.1.27Set SuccessfulCRAFT> get cmiface [1.4.1]Group: cmIfaceTableInstance: [1.4.1.0]PII = 1.4.1.0IfIndex = 1.4.1.0Name= ZebraGroupName= X-rayAdditionalInfo = Comp accountNetModel= VWANIpAddr = 0.0.0.0NetMask = 0.0.0.0MacAddr = 0.60.58.1.0.36BurnedInMacAddr = 0.77.62.18.63.bcFarEndAddr = 0.0.0.0DestPii = 1.2.1.27CMCPCompatible = YesEncapsulationType = rfc1483FwdMode= VWAN Point-to-PointPix = 72Service Class = D3. The MAC address listed for the DSL port in VWANmode is actually the address of the connected router atthe far end of the WAN link. The CE150 still displaysthe Mac Address of the CPE, however, as theBurnedInMacAddr object.4. Enable the WAN interface for Frame Relay.CRAFT> set cmfrdlcmi [1.2.1] adminstate=enabledSet Successful&RSSHU(GJH,QVWDOODWLRQDQG2SHUDWLQJ*XLGH