PDF user manual for CopperEdge 150

6\VWHP&RQILJXUDWLRQIf you suspect the CE150’s configuration data has become unstableor corrupt, you may need to reload the backup configurationfile from a remote file server using cmMaintCmd and itsConfigRestore option as described in Restoring a Backed UpConfiguration on page 111. Implementing the recovered datafile, however, does require a full restart of the CE150 as discussedin the next section.The cmSystem ReadConfig command is not supported in thisrelease.6\VWHP6RIW5HVWDUWIn a major software fault occurs, there may be no alternative torestarting the system. To restart/reboot the CE150, enter thefollowing command:CRAFT> set cmsystem command=restartUsing SCMRestartIn certain relatively rare cases, a system failure could be accompanied(or caused) by an “out of control buffers” state. Ifyou have tried unsuccessfully to soft restart the Control Moduleas described above (set cmboard [1.2] command=restart) andthe system (set cmsystem command=restart), there is one otheralternative recovery procedure: SCMRestart.The SCMRestart command does not require any control buffersto be available. To run this command, enter:CRAFT> scmrestartNote that the entire word must be entered, but it isn’t case-sensitive.You must have Provisioning or greater privileges to executethis command.&RSSHU(GJH,QVWDOODWLRQDQG2SHUDWLQJ*XLGH