PDF user manual for CopperEdge 150

13. If the IP addresses are already set and are differentfrom the ones set in steps 5-9, set either of the twosaved addresses on the IAD (CPE:1.4.13) to zero.CRAFT> set cmcpeiad [cpe:1.4.13]command=savedipaddreraseWhen you perform a Get, you will see the following:CRAFT> get cmcpeiad [cpe:1.4.13]Group: cmCpeIADTableInstance: [CPE:1.4.13]Index= CPE:1.4.13CurrentIpAddr = 10.0.45.2CurrentCAIpAddr = 10.0.45.1SavedIpAddr = 0.0.0.0SavedCAIpAddr = 0.0.0.0NumVoicePorts = 8NumConnections = 8Command= NoneTOSByte = 0LogAction= NoneLogType= ALL(0)LogLevel= INFO(0)LogDuration = 30TotalMsgsLogged = 0Trace1Mask = 0Trace2Mask = 014. Restart the IAD. When the IAD reboots, it asks theCE150 for a new IP address and new IP address for itsvoice gateway. To restart or retrain, use cmCpeBoard(command=restart). To retrain, use ifTable(adminstatus =down, adminstatus=up). Failure torestart/retrain means the IAD to use its old addresses.CRAFT> set iftable [1.4.13] adminstatus=downCRAFT> set iftable [1.4.13] adminstatus=upWhen you perform a Get, you will see this table.CRAFT> get cmcpeiad [cpe:1.4.13]Group: cmCpeIADTableInstance: [CPE:1.4.13]Index= CPE:1.4.13CurrentIpAddr = 10.0.21.2CurrentCAIpAddr = 10.0.21.1SavedIpAddr = 10.0.21.2SavedCAIpAddr = 10.0.21.1NumVoicePorts = 8NumConnections = 8Command= NoneTOSByte = 0LogAction= NoneLogType= ALL(0)LogLevel= INFO(0)LogDuration = 30TotalMsgsLogged = 0Trace1Mask = 0Trace2Mask = 0IAD With New Saved IP Addresses in NVRAMNow on Subnet 10.0.21.0IADHDIA8PhonesIP Addr: 10.0.21.2DSLAMVoiceGatewayIP Addr: 10.0.21.1HDIA Netmodel—Restarting the IAD&RSSHU(GJH,QVWDOODWLRQDQG2SHUDWLQJ*XLGH