PDF user manual for CopperEdge 150

3. If no IP address is specified for the VC’s FarEndAddr (itis 0.0.0.0), the system will use inverse ARP to get theupstream IP address and FwdMode will displayCopperVPNauto. If you set FarEndAddr, the staticsetting overrides the inverse ARP function. TheFwdMode object displays CopperVPN, and outboundpackets go to the location specified. Since CopperVPNDSL interfaces specify a static endpoint (the DestPII),their FwdMode is always CopperVPN.4. At the far end of the CopperVPN link (the upstreamrouter), configure the router to specify the VC.5. In the sample config.txt file for a Cisco Systems router,the settings are the same as for the VWAN netmodel,but without IRB functionality; IP addresses areassigned on the subinterface in its place:version 11.2no service udp-small-serversno service tcp-small-servers!hostname MegaFonsInc!enable password admin!frame-relay switching!interface Ethernet0ip address 192.168.1.1 255.255.255.0!interface Serial0no ip addressencapsulation frame-relay IETFno keepaliveignore-dcdframe-relay intf-type dce!interface Serial0.1 point-to-pointframe-relay interface-dlci 22ip address 192.168.2.1 255.255.255.0!interface Serial0.2 point-to-pointframe-relay interface-dlci 23ip address 192.168.3.1 255.255.255.0!interface Serial0.3 point-to-pointframe-relay interface-dlci 24ip address 192.168.4.1 255.255.255.0!interface Serial1no ip addressencapsulation frame-relay IETFno keepaliveignore-dcdshutdown!no ip classlessip route 0.0.0.0 0.0.0.0 192.168.1.254!snmp-server community public RO!line con 0line aux 0line vty 0line vty 1 4&KDSWHU$GYDQFHG&RQILJXUDWLRQ