PDF user manual for CopperEdge 150

3. Set the VC for data on the WAN port with a vpi(range=0 to 15) and a vci (range=0 to 511). But, reservethe vpi=0 and vci=511 combination for ATM loopbacktesting.CRAFT> set cmatmvcl [1.2.1.20] rowstatus=create vpi=0vci=200 adminstatus=upWhen you perform a Get on the VC to check your work,you will see this table:CRAFT> get cmatmvcl [1.2.1.20]Group: cmAtmVclTableInstance: [1.2.1.20]PII = 1.2.1.20Vpi = 0Vci = 200AdminStatus= UpOperStatus= UpLastChange= 0 day 0 hour 0 min 0.0 secAalType= Aal5Aal5CpcsTransmitSduS = 1600Aal5CpcsReceiveSduSi = 1600RowStatus= ActiveTransmitTrafficDescr = 1OAMState= adminDown(0)OAMAdminState = disabledOAMAutoLBState = disabledOAMManualLBCmd = noneOAMManualLBCmdStatus = noneOAMLBInterval = 5OAMLBTimeOut = 15OAMTxAISCells = 0OAMRxRDICells = 0OAMRxAISCells = 0OAMTxRDICells = 0OAMTxLBRequestCells = 0OAMRxLBResponseCells = 0OAMRxLBRequestCells = 0OAMTxLBResponseCells = 0OAMRxUnsupportedCell = 0OAMTxDiscards = 0OAMRxDiscards = 04. (Optional) If you do not want to set the data subnet forpeer-to-peer traffic, disable the VC for data on the WANport. (The default is enabled.)CRAFT> set cmvpngroup [1.2.1.20] peertopeer=disabledUnless you have a specific reason for disabling peer-topeertraffic, we recommend you leave this optionenabled.&RSSHU(GJH,QVWDOODWLRQDQG2SHUDWLQJ*XLGH