PDF user manual for CopperEdge 150

Multilink Bundle Error MessagesMessage Description ActionIMUX CPE has EndPointIDthat matches member in differentbundleMember PII must be a DSLportMember PII must be on sameshelf as BundlePIIMember Port must have Net-Model set to None to beadded to bundleMember Port must not beconfigured in cmDHCP tableMember Port must not beconfigured in cmFilter tableMember Port must not beconfigured in cmMembertableMember Port must not beunder loopback testingPII value must be a DMLBundlePort cannot be configuredinto multiple entries in a bundlePort is configured in a differentbundleValid RowStatus values:Active, DestroyYou cannot assign a port to a bundlewhen the CPE trained on the port hasan EndPointID that matches the End-PointID of a port in another bundle.All ports in a bundle must have thesame EndPointID.You cannot assign a WAN or Ethernetport to a bundle.This error message does not apply tothe CE150.You must set the netmodel for the IMUXbundle. You cannot set the netmodelseparately for each ports in the bundle.You must set the IMUX bundle forDynamic Host Configuration Protocol.You cannot separately configure eachport in the bundle for DHCP.You must set the filters for the IMUXbundle. You cannot set filters separatelyfor each port in the bundle.You must assign the IMUX bundle to auser group. You cannot separatelyassign each port in a bundle to a group.You cannot assign a port to a bundlewhen it is in loopback testing. Similarly,you cannot perform loopback testing ona port already in a bundle.The PII for an IMUX bundle representsa logical, not a physical, interface. Itmust have the format, 1.51.n, where nis any number from 1 to 63 inclusive.A bundle can have as many as fourports assigned to it. Each port musthave a different PII. The ports can beon the same line card or on differentline cards.You tried to assign the same port to differentbundles. You cannot assign thesame port to different bundles.The default value for RowStatus isActive. The only other acceptablevalue, Destroy, allows you to delete thebundle. You can delete the bundle withoutdeleting ports from the bundle.Enter the command getallcmEndPointPort to list all of theEndPointIDs in the CE150, startingwith the first port on the first linecard.Either switch the port to the otherbundle or attach the correct phoneline to the port. Then add anotherport to the proper bundle andattach the correct phone line.To perform testing on a port in abundle, remove it from the bundle,perform the test, and put it back inthe bundle.Enter the command getallcmBundle to list all IMUX bundleson the CE150 and all portsassigned to them.&KDSWHU7URXEOHVKRRWLQJ