PDF user manual for CopperEdge 150

Change the Factory Default Operator PasswordTo ensure continued system security, you must change thepassword for the factory default operator name. Otherwise, unauthorizedusers could gain access to your system, with fullprivileges to change all settings.Passwords are not completely case sensitive; the first characterof a password may be accepted regardless of case. The systemis case-sensitive to all successive password characters.To change the password:CRAFT> set cmoperator [admin] password=b5c312rSet SuccessfulVerify the change:CRAFT> get cmoperator [admin]Group: cmOperatorInstance: [admin]Name= adminPassword = *******State= activeContext= AllPrivilege= Security1 2 7 (If your system will be managed through an external Radius server,skip the next section. The SNMP Community names will be createdon the Radius server.Create the SNMP Community NamesTo use CopperView AMS, CopperView EM, or another SNMPbasedmanager, you must first configure two operators (anycommunity names, but typically, public and private). The firstoperator must have the View privilege, and the second musthave the Provision privilege. They are to be used in the ReadCommunity and Write Community login prompts, respectively.To create the Public community name:1. From the control console, enter the name, context,state, and operator privilege level.CRAFT> set cmoperator [public] state=createcontext=snmp privilege=viewSet Successful2. Verify the configuration:CRAFT> get cmoperator [public]Group: cmOperatorInstance: [public]Name= publicPassword = **********State= ActiveContext= SNMPPrivilege= View&KDSWHU,QLWLDO&RQILJXUDWLRQ