II - DCE FEL ČVUT v Praze

4.3 Guidelines for Installation, Startup, and Operation
Application in the
system
Operator control and
monitoring: SIMATIC PCS 7
Assigning parameters to
a HART analog module:
PG/PC with STEP 7, or
assigning parameters to
field devices:
PG/PC with SIMATIC PDM
Assigning parameters to field
devices:
PG/PC with SIMATIC PDM
(stand alone)
Smart
field devices
I/O Modules with Intrinsically-Safe Signals
C79000-G7076-C152-04
A sample configuration is used to show you how to start up the HART analog
module with the field devices connected, and the points you should take into
consideration during operation. Further information can be found in the /804/
system overview of the field technology package (supplied on CD). Notes on
the operation of field devices can be found in the online help on
SIMATIC PDM.
MPI
PROFIBUS
DP slave:
IM153-2
HART measuring transducer
for example, SITRANS P
ÉÉ É ÇÇ
É ÇÇÉÉ
ÉÉ É ÇÇ
É ÇÇÉÉ
SIMATIC PCS 7
or other system
Hazardous location
Fig. 4-4 Use of a HART analog module in a sample configuration
Notes on
intrinsically-safe
installation
SIMATIC S7 HART Analog Modules
S7-300 or S7-400 programmable
logic controller with DP-CPU or
DP-CP
ET200M distributed I/O system
with HART analog modules
HART analog input module
HART analog output module
Connecting HART field devices:
to HART analog input channels
or HART analog output channels
HART signal
control elements
for example,
SIPART PS
Nonhazardous
location
You must connect the DM 370 dummy module between the IM 153-2 and
explosion-proof I/O modules, which includes HART I/O modules, whose
signal cables lead into the hazardous area. In a distributed configuration with
an active backplane bus, you should use the explosion-proof partition (6ES7
195-1KA00-0XA0) instead of the dummy module. Additional information on
system design can be found in Sections 1.3 - 1.5.
4-7