AGREEMENT between BROWARD COUNTY and Cummings ...

DIVISION 1 SPECIFICATIONS
SECTION 1045 CUTTING AND PATCHING
Exhibit 2
Page 219 of 379
4. Foundation construction.
5. Bearing and retaining walls.
6. Structural decking.
7. Exterior wall construction.
8. Piping, ductwork, vessels, and equipment.
9. Water, moisture, vapor, air, and smoke barriers, membranes, and
flashing.
10. Noise and vibration control elements and systems.
11. Control, communication, conveying, and electrical wiring systems.
12. Primary operational systems and equipment.
G. For new Work, retain original installer or fabricator, or another recognized
experienced and specialized firm to perform cutting and patching.
1.02 SUBMITTALS
A. Procedural Proposal for Cutting and Patching:
1. Where prior acceptance of cutting and patching is required, submit
proposed procedures for Work well in advance of time Work will be
performed.
2. Including the following information, as applicable, in submittal:
a. Describe nature of Work and how it is to be performed, indicating
why cutting and patching cannot be avoided.
b. Describe anticipated results of Work in terms of change to existing
Work, including structural operational and visual changes as well
as significant elements.
c. List products to be used and firms that will perform Work.
d. Dates when Work is expected to be performed.
e. List utilities that will be disturbed or otherwise be affected by
Work, including utilities that will be relocated and utilities that will
be out-of-service temporarily.
f. Indicate how long utility service will be disrupted.
B. Review of procedural proposal by CPM does not waive CPM’s’s right to later
require complete removal and replacement of Work found to be cut and patched
in unsatisfactory manner.
Section 01045 Cutting and Patching Page 14