AGREEMENT between BROWARD COUNTY and Cummings ...

DIVISION 1 SPECIFICATIONS
SECTION 01340 – SHOP DRAWINGS, PRODUCT DATA AND SAMPLES
F. Submittals that are received from sources other than through CONTRACTOR’s
office will be returned without action. Delays resulting there from shall be
CONTRACTOR’s responsibility.
G. Package each submittal appropriately for transmittal and handling.
H. Distribute reproductions of shop drawings, copies of product data, and samples,
which bear CONSULTANT’s stamp of approval, to jobsite file, record documents
file, subcontractors, suppliers and other entities requiring information.
I. Do not fabricate products or begin work, which required submittals until return of
submittal with CONSULTANT’s and CPM’s acceptance.
1.07 CPM’S AND CONSULTANT’S ACTION:
A. Where action and return is required or requested, CONSULTANT will review
each submittal, mark with action, and where possible return with reasonable
promptness. CPM will forward all comments to the CONSULTANT
1. Where submittal must be held for coordination, CONTRACTOR will be so
advised by the CONSULTANT.
2. Affix stamp and initial or sign, and indicate requirements for resubmittal,
or acceptance of submittal.
3. Return submittals to CONTRACTOR for distribution or for resubmission.
4. CONSULTANT will review submittals for design content only. CPM will
review submittals for construction and installation considerations.
B. Final Unrestricted Release: When submittal is returned marked “No Exceptions
Taken”, work may proceed, provided it complies with Contract Documents.
C. Final-But-Restricted-Release: When submittal is returned marked “Note
Markings”, Work may proceed, provided it complies with notations and
corrections on submittal and with Contract Documents.
D. Returned for Resubmittal:
Exhibit 2
Page 282 of 379
1. When submittal is returned marked “Revise and Resubmit” or is
unmarked, do not proceed with Work.
2. Revise submittal in accordance with notations and resubmit without delay
to obtain difference action marking.
E. Other Action: Where submittal is returned for other reasons, with the CPM or
CONSULTANT’s explanation included, it will be marked “Not Accepted”.
PART 2 - PRODUCTS
PART 3 - EXECUTION
(Not Used)
(Not Used)
ATTACHMENTS:
Submittal Transmittal
Section 01340 Shop Drawings, Product Data and Samples Page 77