AGREEMENT between BROWARD COUNTY and Cummings ...

DIVISION 1 SPECIFICATIONS
SECTION 01540 CONSTRUCTION SAFETY PLAN AND SECURITY REQUIREMENTS
a. Prior to the commencement of any demolition or other Work,
which will cause an interruption, or modification to existing aircraft
operations, the CONTRACTOR shall confer with and obtain,
written authorization from the CPM.
b. If the CONTRACTOR requires access to operational areas not
delineated on the Construction Safety Plan Drawing(s), the
CONTRACTOR shall participate in negotiations leading to the
imposition of restrictions on airport operations in the affected
areas, he shall strictly abide by all conditions imposed by BCAD
relating to his entry and use of such area and he shall not enter
these areas until granted temporary, conditional entry clearance
BCAD – Operations.
c. Trenching, excavation and other work requiring temporary runway
or taxiway closure shall be limited by the CONTRACTOR to that
amount of work that can be completed within the hours of minimal
operation. All ditches, excavations, etc. shall be restored prior to
the end of the Work period and affected pavements returned to
service. This Work shall be scheduled during hours of minimal
operations. Hours of minimal operation shall be the hours
between 10:00 p.m. and 6:00 a.m. All other hours shall be hours
of normal operation.
d. The CONTRACTOR may be required to pursue affected portions
of the Work on a continuous 24-hour per day basis during
construction of the various phases and subphases shown on the
Drawings and described in the Contract Documents (such as
when runways or taxiways, aprons, service or other access
roadways, service gates are closed for operations or when
hazards of any kind arise).
e. The CPM will arrange with BCAD Operations for inspection prior
to opening for aircraft use any taxiway that has been used for a
crossing point or haul route by the CONTRACTOR.
4. Operations Safety Inspection:
Exhibit 2
Page 305 of 379
a. The entire Work Site shall be inspected daily and more frequently
if construction activities are of a nature that debris may
accumulate on AOA pavements. Special inspections shall be
conducted for each Work Area prior to return to service for aircraft
operation. The purpose of these inspections is to ascertain that
areas returned to aircraft service are in satisfactory condition and
that the overall Work Site and its activities are within the safety
criteria set forth in these Contract Documents. Inspections shall
be conducted jointly by representatives of the CONTRACTOR,
BCAD-Operations, the CPM and the airlines.
b. Any violations of safety criteria found during these inspections
shall be rectified immediately. If a violation cannot be corrected
on an immediate basis by the CONTRACTOR, he shall
immediately notify the CPM. No areas shall be approved for
operations with violations occurring unless specifically authorized
by BCAD-Operations, the CPM and the designated airline
Section 01540 Construction Plan and Safety Requirements Page 100