AGREEMENT between BROWARD COUNTY and Cummings ...

DIVISION 1 SPECIFICATIONS
SECTION 1045 CUTTING AND PATCHING
Exhibit 2
Page 220 of 379
PART 2 - PRODUCTS
2.01 MATERIALS
A. Use materials for cutting and patching that are identical to existing materials. If
identical materials are not available, or cannot be used, use materials that match
existing adjacent surfaces to fullest extent possible with regard to visual effect.
B. Use materials for cutting and patching that will result in equal-or-better
performance characteristics.
C. Comply with specifications and standards for each specific product involved.
PART 3 - EXECUTION
3.01 EXAMINATION
A. Before cutting, examine surfaces and conditions under which Work is to be
performed. If unsafe or otherwise unsatisfactory conditions are encountered,
take corrective action before proceeding with Work.
B. Before start of cutting Work, meet at Work Site with all parties involved in cutting
and patching, including mechanical and electrical trades. Review areas of
potential interference and conflict between various trades. Coordinate layout of
Work and resolve potential conflict before proceeding with Work.
3.02 PREPARATION
A. Provide adequate temporary support as necessary to assure structural value or
integrity of affected portion of Work.
B. Protect other Work during cutting and patching to prevent damage. Provide
protection from adverse weather conditions for that part of project that may be
exposed during or after cutting and patching operations.
C. Avoid interference with use of adjoining areas or interruption of free passage to
adjoining areas.
D. Take precautions not to cut existing pipe, conduit, or duct serving building but
schedule to be relocated until provisions have been made to bypass them.
Section 01045 Cutting and Patching Page 15