AGREEMENT between BROWARD COUNTY and Cummings ...

DIVISION 1 SPECIFICATIONS
SECTION 01340 – SHOP DRAWINGS, PRODUCT DATA AND SAMPLES
and control piping, and all other items of information that area required to
demonstrate detail compliance with the Drawings and Specifications.
6. If the CONTRACTOR proposes equipment requiring materially different
layout from that shown on the Drawings and if such substitution is
acceptable to the CPM and the CONSULTANT, the CONTRACTOR shall
submit drawings showing the revised layout of all affected structures,
piping and equipment.
7. The CPM’s and the CONSULTANT’s review of the CONTRACTOR’s
shop drawings signifies only that such drawings appear to be in
conformity with the Contract Documents or with the CPM’s or
CONSULTANT’s instructions. Such review does not indicate approval of
every detail of the drawings nor of the Work methods of the
CONTRACTOR which are indicated thereon.
8. Regardless of the corrections made in, or reviews given to such drawings
by the CPM or the CONSULTANT, the CONTRACTOR will nevertheless
be responsible for the accuracy of such drawings, for their conformity to
the Drawings and Specifications, and for the proper fitting and
construction of the Work.
B. SHOP DRAWINGS:
Exhibit 2
Page 276 of 379
1. Composite Shop Drawings shall be prepared by the CONTRACTOR
where the CPM determines them to be required for coordination of the
Work, including but not limited to:
a. Where Work by separate entities requires off-site fabrication of
products and materials which must be accurately interfaced and
closely intermeshed to produce required results, prepare
composite drawings to indicate how work shown by separate shop
drawings will be interfaced, intermeshed and sequenced for
installation.
b. Prepare drawings to indicate how Work shown by separate civil,
structural, mechanical, and electrical shop drawings shall be
interfaced, intermeshed and sequenced for installation.
c. Prepare drawings for window walls showing integration of
structural systems, glass, plaster, and other items making up
principal wall system.
d. No more than three (3) weeks before materials are fabricated or
Work has begun, CONTRACTOR shall submit to CPM and
CONSULTANT complete, composite, blackline drawings. Prepare
using ¼” minimum scale with congested areas and sections
through shafts at 3/8” minimum scale. Submit total sleeving
drawings.
e. CONTRACTOR shall be responsible for coordination of Work.
Each architectural, civil, structural, mechanical, and electrical
subcontractor shall be responsible for coordination of their
portions of the Work with Contract and with each affected trade.
f. CONTRACTOR shall resolve conflicts, certify blackline drawings
with signature of authorized person, and submit blackline
drawings to CONSULTANT through the CPM.
Section 01340 Shop Drawings, Product Data and Samples Page 71