AGREEMENT between BROWARD COUNTY and Cummings ...

DIVISION 1 SPECIFICATIONS - SECTION 01500 TEMPORARY FACILITIES
B. Storage and Fabrication Sheds: Install storage and fabrication sheds, sized,
furnished and equipped to accommodate materials and equipment involved,
including temporary utility service. Sheds may be open shelters or fully enclosed
spaces within the building or elsewhere on the site. Final location is subject to
CPM’s approval.
C. Do not use existing facilities for field offices or for storage unless otherwise
directed by the CPM. Locate office and storage trailers as directed by CPM.
D. Field Office: Weather tight, with lighting, electrical outlets, heating, cooling and
ventilating equipment, and equipped with sturdy furniture drawing rack and
drawing display table.
E. Locate offices and sheds minimum distance of 30 feet from new structures.
F. Do not use permanent facilities for field offices unless otherwise directed by the
CPM.
G. Construction: Portable or mobile buildings, or buildings constructed with floors
raised above ground, securely fixed to foundations with steps and landings at
entrance doors.
1. Construction: Structurally sound, secure, weather tight enclosures for
office and storage spaces. Maintain during progress of Work; remove at
completion of Work.
2. Temperature Transmission Resistance of Floors, Walls, and Ceilings:
Compatible with occupancy and storage requirements.
3. Exterior Materials: Weather resistant, finished in one color acceptable to
CPM.
4. Interior Materials in Offices: Sheet type materials for walls and ceilings,
pre-finished or painted; resilient floors and bases.
5. Lighting for Offices: 50 footcandles at desk top height, exterior lighting at
entrance doors
6. Fire Extinguishers: Appropriate type fire extinguisher at each office and
each storage area.
7. Interior Materials in Storage Sheds: As required to provide specified
conditions for storage of products.
H. Environmental Control:
Exhibit 2
Page 297 of 379
1. Heating, Cooling, and Ventilating for Offices: Automatic equipment to
maintain comfort conditions, 68 degrees F (20 degrees C) heating and 76
degrees F (23 degrees C) cooling.
2. Storage Spaces: Heating and ventilation as needed to maintain products
in accordance with Contract Documents; lighting for maintenance and
inspection of products.
I. Storage Areas And Sheds: Size to storage requirements for products of
individual Sections, allowing for access and orderly provision for maintenance
and for inspection of products to requirements of Section 01600.
Section 01500 Temporary Facilities Page 92