AGREEMENT between BROWARD COUNTY and Cummings ...

DIVISION 1 SPECIFICATIONS
SECTION 01255 CPEAM PROCEDURES
Exhibit 2
Page 235 of 379
1. When the Work requires closing an Air Operations Area (AOA) of the
Airport or portion of such area, the CONTRACTOR shall furnish, erect,
and maintain temporary markings and associated lighting conforming to
the requirements specified in the Contract Documents as applicable, or of
FAA Advisory Circular 150/5340-1E, “Marking of Paved Areas on
Airports.”
2. The CONTRACTOR shall furnish and erect all barricades, warning signs,
and markings for hazards prior to commencing Work, which requires such
erection and shall maintain the barricades, warning signs, and markings
for hazards until their dismantling is directed by the CONSULTANT.
3. Refer to Section 01540 - CONSTRUCTION SAFETY PLAN AND
SECURITY REQUIREMENTS for additional requirements.
O. Maintenance of Devices and Barriers: Traffic control devices, warning devices
and barriers shall be kept in the correct position, properly directed, clearly visible
and clean, at all times. Damaged, defaced, or dirty devices or barriers shall
immediately be repaired, replaced or cleaned as directed.
P. Flagmen: The CONTRACTOR shall provide competent flagmen to direct traffic
where one-way operation in a single lane is in effect, where airside traffic
movement is affected by CONTRACTOR’s operations, and in other situations as
may be required by the standards established herein.
Q. CONTRACTOR Signing: The CONTRACTOR may furnish and install
construction traffic directional signs along the existing traffic route. The signs
shall depict CONTRACTOR’s logo or name, directional arrows and “deliveries.”
Signs shall be of sufficient size to have 6” high message and shall be located at
each decision point. The CPM shall approve all signs and their locations. NO
OTHER SIGNS ARE PERMITTED WITHIN THE AIRPORT COMPLEX.
R. Material Deliveries: The CONTRACTOR shall make his own material and
equipment deliveries. Vendors or suppliers shall make no deliveries without a
representative of the CONTRACTOR being present to coordinate it.
S. All dollies, floats or other conveyances used for debris removal shall be rubber
tired, box type, and lined with plastic barrier to prevent debris falling from the
cart. All carts are to be loaded within the confines of the dust barrier. Transport
of debris through public spaces, if permitted, will be made only after coordination
of times and routes with the CPM.
T. Notification: On days when construction traffic is expected to be extra heavy or
when oversized pieces of equipment are to be delivered, give the CPM a
minimum of seventy-two (72) hours notice prior to the event.
Section 01255 CPEAM Procedures Page 30