AGREEMENT between BROWARD COUNTY and Cummings ...

DIVISION 1 SPECIFICATIONS
SECTION 01340 – SHOP DRAWINGS, PRODUCT DATA AND SAMPLES
samples to subcontractors, suppliers, fabricators, manufacturers,
installers, governing authorities, and others as required for proper
performance of the Work. Show final distribution on transmittal forms.
4. Mock-Ups: Mock-ups are special form of samples, which are too
large or otherwise inconvenient for handling in specified manner for
transmittal of sample submittals. Mock-ups and similar samples specified
in individual Work sections recognized as a special type of sample.
Comply with requirements for sample to greatest extent possible, and
process transmittal forms to provide records of activity.
a. Field Samples:
E. MISCELLANEOUS SUBMITTALS:
Exhibit 2
Page 280 of 379
(1) Construct mock-up for CONSULTANT’s and CPM’s visual
examination, for quality control, and performance of
required testing.
(2) Erect at location acceptable to CPM.
(3) Size of Area: As specified in respective Specification
Section.
(4) Fabricate each sample and mock-up complete and finished
using materials, fabrication, and installation methods
identical with those indicated for Work.
(5) Remove mock-ups at conclusion of Work or when
acceptable to CPM if not incorporated into Work.
1. Inspection and Test Reports: Classify each inspection and test report as
being either “shop drawings” or “product data” depending on whether the
report is specially prepared for the project, or a standard publication of
workmanship control testing at the point of production. Process
inspection and test reports accordingly.
2. Warranties: Refer to Section 01740 - WARRANTIES, for specific general
requirements on warranties, product bonds, workmanship bonds and
maintenance agreements. In addition to copies desired for the
CONTRACTOR’s use, furnish two (2) executed copies of such
warranties, bonds, or agreements. Provide two (2) additional copies
where required for maintenance manuals.
3. Survey Data: Refer to Section 01040 - PROJECT COORDINATION, for
specific general requirements on property surveys, field measurements,
and quantitative records of actual Work, damage surveys and similar data
required by the individual sections. None of the specified copies will be
returned.
4. Standards: Where submittal of a copy of a standard is indicated, and
except where copies of standards are specified as an integral part of a
“Product Data” submittal, submit a single copy of standards for the
CONSULTANT’s use. Where workmanship, whether at the project site or
elsewhere is governed by a standard, furnished additional copies of the
standard to fabricators, installers and others involved in the performance
of the Work.
5. Closeout Submittals: Refer to Section 01770 - PROJECT CLOSEOUT,
and to individual section of these specifications for specific submittal
Section 01340 Shop Drawings, Product Data and Samples Page 75