AGREEMENT between BROWARD COUNTY and Cummings ...

DIVISION 1 SPECIFICATIONS
SECTION 01540 CONSTRUCTION SAFETY PLAN AND SECURITY REQUIREMENTS
representative.
G. Open flame torch cutting or welding is prohibited unless adequate safety
precautions have been taken and approved by the CPM. Use of explosively
operated fastening devices within the confines of the Airport is strictly prohibited.
H. The CONTRACTOR shall preserve and/or protect existing and new pavements
plus other facilities from damage due to construction operations. Existing
pavements and facilities that are damaged shall be replaced or reconstructed to
original strength at the CONTRACTOR’s expense. The CONTRACTOR shall
take immediate action to reconstruct any damaged area that is to remain in
service. Unless indicated on the Drawings, existing pavements shall not be cut
for the installation of any utilities. Jack and bore method shall be required.
I. CONSTRUCTION AREA LIMITS:
Exhibit 2
Page 306 of 379
1. FAA Advisory Circular 150/5370-2C, Appendix 1, prohibits construction
activity within 125-feet of an active runway (open for aircraft use) edge or
within the Obstacle Free Zone 150/5370-2C further restricts construction
activity within 83.5-feet of the edge of the taxiway (48.5-feet of the
shoulder edge) when the aircraft using the taxiway includes aircraft such
as the B-747. The activity limits shall be adequately signed and marked
by the CONTRACTOR to preclude violation of this restriction. The area
shall be well identified by warning signs and lights at night. The
CONTRACTOR shall install lighting, marking, barricades, signs and other
measures to delineate closed and hazardous area during construction.
The guidance and procedures provided by FAA Advisory Circular AC
150/5340-1E, “Marking of Paved Areas on Airports”, shall be utilized as
depicted on the Drawings. Barricades shall be weighted or otherwise
secured to sufficiently prevent displacement by aircraft engine and
propeller blast and ambient winds. Steady burning red obstruction lights
may be required in certain instances to supplement lighted barricades or
highlight hazardous or potentially dangerous objects. The location of
these lights will be as depicted on the Drawings or requested in the field
by the CPM. Obstruction lights and barricades shall not be located within
runway, taxiway or taxi lane obstacle clearance areas.
2. The limits of construction, material storage area, plant site, equipment
storage area, parking area and other areas defined as required for the
CONTRACTOR’s exclusive use during construction shall be marked by
the CONTRACTOR. The CONTRACTOR may erect and maintain around
the perimeter of these areas suitable marking and warning devices visible
for day/night use. Temporary fencing, barricades, flagging and/or flashing
warning lights will be required at critical access points. Type of marking
and warning devices shall be approved by CPM. Open trenches,
excavations and stockpiled materials shall be permanently marked with
flags and lighted by approved light units during hours of reduced visibility
and darkness. No separate pay item is included for this Work and all
costs must be included in the Lump Sum Bid.
J. As designated on the Drawings, the CONTRACTOR shall erect and maintain
Section 01540 Construction Plan and Safety Requirements Page 101