Attachment 1: Specifications - Metropolitan Washington Airports ...

DCA TERMINAL A IMPROVEMENTS (NEAR TERM) 10 AUGUST 2012
TASK ORDER 03: LOBBY IMPROVEMENTS – PKG 4 - CURBSIDE CHECK-IN
RONALD REAGAN WASHINGTON NATIONAL AIRPORT
PROJECT DT1203
5. Permanent Fire Protection: At earliest feasible date in each area of Project, complete
installation of permanent fire-protection facility, including connected services, and place
into operation and use. Instruct key personnel on use of facilities.
6. Develop and supervise an overall fire-prevention and first-aid fire-protection program for
personnel at Project site. Review needs with local fire department and establish
procedures to be followed. Instruct personnel in methods and procedures. Post warnings
and information.
7. Provide temporary standpipes with fire hose valve connections for fire protection.
8. Storage: Where materials and equipment are stored, and are of value or attractive for
theft, provide secure lockup. Enforce discipline in connection with installation and
release of material to minimize opportunity for theft and vandalism.
3.5 OPERATION, TERMINATION, AND REMOVAL
A. Supervision: Enforce strict discipline in use of temporary facilities. Limit availability of
temporary facilities to essential and intended uses to minimize waste and abuse.
B. Maintenance: Maintain facilities in good operating condition until removal. Protect from
damage caused by freezing temperatures and similar elements.
1. Maintain operation of temporary enclosures, heating, cooling, humidity control,
ventilation, and similar facilities on a 24-hour basis where required to achieve indicated
results and to avoid possibility of damage.
2. Prevent water-filled piping from freezing. Maintain markers for underground lines.
Protect from damage during excavation operations.
A. Operate Project-identification-sign lighting daily any time from dusk until dawn when
personnel are on the site. Should no personnel be on the site after 12:00 midnight the project –
identification lighting may be turned off at 12:00 midnight.
B. Temporary Facility Changeover: Unless Contractor is able to utilize permanent fire protection,
do not change over from using temporary security and protection facilities to permanent
facilities until Substantial Completion.
C. Termination and Removal: Remove each temporary facility when need for its service has
ended, when it has been replaced by authorized use of a permanent facility, or no later than
Substantial Completion. Complete or, if necessary, restore permanent construction that may
have been delayed because of interference with temporary facility. Repair damaged Work, clean
exposed surfaces, and replace construction that cannot be satisfactorily repaired.
1. Properly recondition and restore those portions of the site occupied by temporary
facilities and controls to condition acceptable to COTR, at least equal to condition at time
of start of Work, unless otherwise authorized in writing by COTR.
2. Materials and facilities that constitute temporary facilities are the property of Contractor.
The Authority reserves right to take possession of Project identification signs.
1. Remove temporary paving not intended for or acceptable for integration into permanent
paving. Where area is intended for landscape development, remove soil and aggregate fill
that do not comply with requirements for fill or subsoil. Remove materials contaminated
with road oil, asphalt and other petrochemical compounds, and other substances that
TEMPORARY FACILITIES AND CONTROLS 01 50 00 - 11