Attachment 1: Specifications - Metropolitan Washington Airports ...

DCA TERMINAL A IMPROVEMENTS (NEAR TERM) 10 AUGUST 2012
TASK ORDER 03: LOBBY IMPROVEMENTS – PKG 4 - CURBSIDE CHECK-IN
RONALD REAGAN WASHINGTON NATIONAL AIRPORT
PROJECT DT1203
3.3 APPLICATION
A. Apply paints according to manufacturer's written instructions and recommendations in "MPI
Manual."
B. Apply paints to produce surface films without cloudiness, spotting, holidays, laps, brush marks,
roller tracking, runs, sags, ropiness, or other surface imperfections. Cut in sharp lines and color
breaks.
3.4 CLEANING AND PROTECTION
A. Protect work of other trades against damage from paint application. Correct damage to work of
other trades by cleaning, repairing, replacing, and refinishing, as approved by COTR, and leave
in an undamaged condition.
B. At completion of construction activities of other trades, touch up and restore damaged or
defaced painted surfaces.
3.5 EXTERIOR PAINTING SCHEDULE
A. Concrete Substrates, Nontraffic Surfaces:
1. Latex Aggregate System:
a. Prime Coat: As recommended in writing by topcoat manufacturer.
b. Intermediate Coat: As recommended in writing by topcoat manufacturer.
c. Topcoat: Textured coating, latex, flat, MPI #42.
B. Exterior Gypsum Board Substrates:
1. Latex Aggregate System:
a. Prime Coat: Latex, exterior, matching topcoat.
b. Intermediate Coat: Latex, exterior, matching topcoat.
c. Topcoat: Textured coating, latex, flat, MPI #42.
PART 4 - CONTRACTOR’S QUALITY CONTROL REQUIREMENTS
4.1 GENERAL
A. Comply with applicable provisions of Division 01 Section “Quality Requirements” for
requirements for Contractor Quality Control Program.
END OF SECTION 09 91 13
EXTERIOR PAINTING 09 91 13 - 4