Attachment 1: Specifications - Metropolitan Washington Airports ...

More documents

Recommendations

Info

DCA TERMINAL A IMPROVEMENTS (NEAR TERM) 10 AUGUST 2012 TASK ORDER 03: LOBBY IMPROVEMENTS – PKG 4 - CURBSIDE CHECK-IN RONALD REAGAN WASHINGTON NATIONAL AIRPORT PROJECT DT1203 2. All telecommunications raceways shall be installed per the latest issue of the TIA/EIA- 569A Standards and shall comply with the National Electrical Code and all other applicable state and local codes and regulations. 3. All telecommunication raceways shall be grounded per NEC requirements. 4. The minimum size of conduits used for raceways shall be no less than 1-inch trade size. No section of conduit shall be longer than 100 feet between pull points and shall contain no more than 180 degrees of total bend. The inside bend radius of conduits shall be at least 6 times the internal diameter for conduits under 2 inches and 10 times the internal diameter for conduits 2 inches and larger. In no case shall conduit bodies or LB’s be used. All conduits shall be terminated with bushings. 5. Pull boxes should be placed in straight sections of conduit and not used in lieu of a bend. Pull boxes shall have a length of at least 8 times the trade-size diameter of the largest conduit. 6. All conduit bends shall be sweeping and shall not be smaller than the manufacturer’s stated minimum bend radius for cable during installation. 7. Provide pull stings in all conduits for installation of the cables by the Contractor. 8. Label all telecommunications conduits at regular intervals and at each side of junction or pull boxes. C. Fire And Smoke Partition Penetrations: 1. Sealing of openings between floors, through rated fire and smoke walls, existing or created by this Contractor for cable pass through shall be the responsibility of the PWDS Contractor. Sealing material and application of this material shall be accomplished in such a manner that is acceptable to the local fire and building authorities having jurisdiction over this work. Any openings created by or for this Contractor and left unused shall also be sealed as part of this work. 2. Conduit sleeves have been provided as a means of routing cables between various equipment rooms and into the cable tray in the ceiling space. Openings in sleeves and conduits used for the PWDS system cables shall be sealed with an approved fireproof, removable material in accordance with Division 07 Section “Penetration Firestopping.” 3. Additional penetrations through rated assemblies necessary for passage of PWDS wiring shall be made using an approved method and permanently sealed after installation of cables. PART 4 - CONTRACTOR’S QUALITY CONTROL REQUIREMENTS 4.1 GENERAL A. Comply with applicable provisions of Division 01 Section “Quality Requirements” for requirements for Contractor Quality Control Program. END OF SECTION 27 05 28 PATHWAYS FOR COMMUNICATIONS SYSTEMS 27 05 28 - 6
DCA TERMINAL A IMPROVEMENTS (NEAR TERM) 10 AUGUST 2012 TASK ORDER 03: LOBBY IMPROVEMENTS – PKG 4 - CURBSIDE CHECK-IN RONALD REAGAN WASHINGTON NATIONAL AIRPORT PROJECT DT1203 SECTION 27 10 00 – PREMISE WIRING DISTRIBUTION SYSTEM PART 1 - GENERAL 1.1 SUMMARY A. Systems Description 1. The Premise Wiring Distribution System (PWDS) specified herein and in related specifications sections will support the connectivity requirements of the <strong>Metropolitan</strong> <strong>Washington</strong> Airport Authority (MWAA) and Transportation Security Administration (TSA) operations in the new facility being constructed to house the new Terminal A Security Screening Check Point (SSCP). 2. The PWDS design includes communications outlets, station cables, backbone cables, termination and cable management hardware, communications rooms and other spaces dedicated to TSA operations. Additional requirements are indicated on the plans that serve MWAA. Interfaces between the PWDS serving MWAA and the PWDS serving the TSA are also indicated on the plans. The combination of these systems comprises a single PWDS for the SSCP Project. 1.2 SCOPE OF WORK A. Furnish and install, complete with all accessories, a Premise Wiring Distribution System (PWDS) consisting of single mode fiber optic (SMF) cables, multimode fiber optic (MMF) cables, Category 6 station cables, Category 3 voice grade cables and other cabling as described herein and shown on the Drawings for the SSCP Project. B. The PWDS shall provide wiring, cable, pathways, connectors, copper and fiber optic termination systems, terminations, system administration and testing as defined herein and in applicable related documents. C. The PWDS system shall serve as a vehicle for transport of signals from new and existing telecommunications and electronic systems and for all of the new telecommunications and applicable electronic systems specified in Divisions 27 and 28. D. The primary elements of the PWDS system includes: 1. The provision, installation, termination and cross connect and patching of SMF fiber optic cables, category 6A voice and data cables and Category 3 voice grade cables in the facilities and locations as indicated on the Drawings and specified herein. 2. Provision and installation of cable connectors, termination facilities and hardware for fiber optic and copper cables required as part of this work. 3. Provision and installation of copper and fiber optic cross connect hardware including fiber optic jumpers and cross connect wiring and patch cords required to achieve specified systems operation. PREMISE WIRING DISTRIBUTION SYSTEM 27 10 00 - 1
Page 1:
TECHNICAL SPECIFICATIONS VOLUME I O
Page 4 and 5:
DCA TERMINAL A IMPROVEMENTS (NEAR T
Page 6 and 7:
THIS PAGE INTENTIONALLY LEFT BLANK
Page 8 and 9:
Page 10 and 11:
DCA TERMINAL A IMPROVEMENTS 10 AUGU
Page 12 and 13:
Page 14 and 15:
Page 16 and 17:
Page 18 and 19:
Page 20 and 21:
Page 22 and 23:
Page 24 and 25:
Page 26 and 27:
Page 28 and 29:
Page 30 and 31:
Page 32 and 33:
Page 34 and 35:
Page 36 and 37:
Page 38 and 39:
Page 40 and 41:
Page 42 and 43:
Page 44 and 45:
Page 46 and 47:
Page 48 and 49:
Page 50 and 51:
Page 52 and 53:
Page 54 and 55:
Page 56 and 57:
Page 58 and 59:
Page 60 and 61:
Page 62 and 63:
Page 64 and 65:
Page 66 and 67:
Page 68 and 69:
Page 70 and 71:
Page 72 and 73:
Page 74 and 75:
Page 76 and 77:
Page 78 and 79:
Page 80 and 81:
Page 82 and 83:
Page 84 and 85:
Page 86 and 87:
Page 88 and 89:
Page 90 and 91:
Page 92 and 93:
Page 94 and 95:
Page 96 and 97:
Page 98 and 99:
Page 100 and 101:
Page 102 and 103:
Page 104 and 105:
Page 106 and 107:
Page 108 and 109:
Page 110 and 111:
Page 112 and 113:
Page 114 and 115:
Page 116 and 117:
Page 118 and 119:
Page 120 and 121:
Page 122 and 123:
Page 124 and 125:
Page 126 and 127:
Page 128 and 129:
Page 130 and 131:
Page 132 and 133:
Page 134 and 135:
Page 136 and 137:
Page 138 and 139:
Page 140 and 141:
Page 142 and 143:
Page 144 and 145:
Page 146 and 147:
Page 148 and 149:
Page 150 and 151:
Page 152 and 153:
Page 154 and 155:
Page 156 and 157:
Page 158 and 159:
Page 160 and 161:
Page 162 and 163:
Page 164 and 165:
Page 166 and 167:
Page 168 and 169:
Page 170 and 171:
Page 172 and 173:
Page 174 and 175:
Page 176 and 177:
Page 178 and 179:
Page 180 and 181:
Page 182 and 183:
Page 184 and 185:
Page 186 and 187:
Page 188 and 189:
Page 190 and 191:
Page 192 and 193:
Page 194 and 195:
Page 196 and 197:
Page 198 and 199:
Page 200 and 201:
Page 202 and 203:
Page 204 and 205:
Page 206 and 207:
Page 208 and 209:
Page 210 and 211:
Page 212 and 213:
Page 214 and 215:
Page 216 and 217:
Page 218 and 219:
Page 220 and 221:
Page 222 and 223:
Page 224 and 225:
Page 226 and 227:
Page 228 and 229:
Page 230 and 231:
Page 232 and 233:
Page 234 and 235:
Page 236 and 237:
Page 238 and 239:
Page 240 and 241:
Page 242 and 243:
Page 244 and 245:
Page 246 and 247:
Page 248 and 249:
Page 250 and 251:
Page 252 and 253:
Page 254 and 255:
Page 256 and 257:
Page 258 and 259:
Page 260 and 261:
Page 262 and 263:
Page 264 and 265:
Page 266 and 267:
Page 268 and 269:
Page 270 and 271:
Page 272 and 273:
Page 274 and 275:
Page 276 and 277:
Page 278 and 279:
Page 280 and 281:
Page 282 and 283:
Page 284 and 285:
Page 286 and 287:
Page 288 and 289:
Page 290 and 291:
Page 292 and 293:
Page 294 and 295:
Page 296 and 297:
Page 298 and 299:
Page 300 and 301:
Page 302 and 303:
Page 304 and 305:
Page 306 and 307:
Page 308 and 309:
Page 310 and 311:
Page 312 and 313:
Page 314 and 315:
Page 316 and 317:
Page 318 and 319:
Page 320 and 321:
Page 322 and 323:
Page 324 and 325:
Page 326 and 327:
Page 328 and 329:
Page 330 and 331:
Page 332 and 333:
Page 334 and 335:
Page 336 and 337:
Page 338 and 339: DCA TERMINAL A IMPROVEMENTS (NEAR T
Page 344 and 345: THIS PAGE INTENTIONALLY LEFT BLANK
Page 438 and 439:
Page 440 and 441:
Page 442 and 443:
Page 444 and 445:
Page 446 and 447:
Page 448 and 449:
Page 450 and 451:
Page 452 and 453:
Page 454 and 455:
Page 456 and 457:
Page 458 and 459:
Page 460 and 461:
Page 462 and 463:
Page 464 and 465:
Page 466 and 467:
Page 468 and 469:
Page 470 and 471:
Page 472 and 473:
Page 474 and 475:
Page 476 and 477:
Page 478 and 479:
Page 480 and 481:
Page 482 and 483:
Page 484 and 485:
Page 486 and 487:
Page 488 and 489:
Page 490 and 491:
Page 492 and 493:
Page 494 and 495:
Page 496 and 497:
Page 498 and 499:
Page 500:
show all

Attachment 1: Specifications - Metropolitan Washington Airports ...

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?