Cisco Broadband Cable Command Reference Guide

Chapter 2 Cisco Cable Modem Termination System Commands
cable modem access-group
Syntax Description
OL-1581-05
cable modem access-group
To specify the access-group for a CM, use the cable modem access-group command in privileged
EXEC mode. To disable the specification, use the no access-group form of this command.
cable modem {mac-addr | ip-addr} access-group [access-list | access-name]
cable modem {mac-addr | ip-addr} no access-group
Note The cable modem access-group command is not supported on the Cisco uBR10012 universal
broadband router.
Defaults No default behaviors or values
Command Modes Privileged EXEC
Command History
Examples The following example shows the cable modem access-group command assigning access-list 1 to the
CM with the MAC address of abcd.ef01.2345:
Related Commands
ip-addr Specifies the IP address for the CM.
mac-address Specifies the MAC address for the CM.
access-list Specifies the IP access list (standard or extended). Valid values are 1
to 199.
access-name Specifies the access-list name.
Release Modification
11.3(8) NA This command was introduced.
router# cable modem abcd.ef01.2345 access-group 1
Command Description
cable modem
change-frequency
Changes the downstream frequency or upstream channel ID.
cable modem
max-hosts
Specifies the maximum hosts for a CM.
cable modem qos
profile
Specifies the QoS profile for a CM.
show cable modem Displays CM configuration settings.
Cisco Broadband Cable Command Reference Guide
2-95