Cisco Broadband Cable Command Reference Guide

clear cable modem delete
clear cable modem delete
Syntax Description
2-266
Cisco Broadband Cable Command Reference Guide
Chapter 2 Cisco Cable Modem Termination System Commands
To remove one or more CMs from the internal address and routing tables, use the clear cable modem
delete command in privileged EXEC mode.
Defaults No default behavior or values
Command Modes Privileged EXEC
Command History
clear cable modem {mac-addr | ip-addr | cable slot/port {all | oui string | reject} } delete
clear cable modem {mac-addr | ip-addr | cable slot/subslot/port {all | oui string | reject} } delete
mac-addr Specifies the 48-bit hardware address (MAC address) of an individual
CM.
ip-addr Specifies the IP address of an individual CM.
cable slot/port Identifies the a interface and downstream port on the Cisco uBR7100
series and Cisco uBR7200 series routers.
On the Cisco uBR7100 series router, the only valid value is 1/0. On the
Cisco uBR7200 series router, slot can range from 3 to 6, and port can
be 0 or 1, depending on the cable interface.
cable slot/subslot/port Identifies a cable interface on the Cisco uBR10012 router. The
following are the valid values:
slot = 5 to 8
subslot = 0 or 1
port = 0 to 4 (depending on the cable interface)
all Deletes all the CMs from the Station Maintenance List.
oui string Deletes all CMs that match the specified Organization Unique
Identifier (OUI). The string parameter can be either the three byte
hexadecimal string (such as 00.00.0C) or a vendor name that has been
defined using the cable modem vendor command.
reject Deletes all CMs that are currently in one of the reject states (see the
description of these states in the show cable modem command).
Release Modification
12.2(11)BC3 This command was introduced for the Cisco uBR7100 series,
Cisco uBR7200 series, and Cisco uBR10012 universal broadband routers.
Usage Guidelines This command instructs the Cisco CMTS to stop sending DOCSIS station maintenance messages to one
or more CMs, which effectively terminates the link to those CMs. To remove one or more CMs from the
router’s internal tables and to instruct them to reset, use the clear cable modem reset command.
OL-1581-05