Cisco Broadband Cable Command Reference Guide

clear cable modem counters
clear cable modem counters
Syntax Description
2-264
Cisco Broadband Cable Command Reference Guide
Chapter 2 Cisco Cable Modem Termination System Commands
To reset the CM flap-list counters to zero, use the clear cable modem counters command in privileged
EXEC mode.
Defaults No default behavior or values
Command Modes Privileged EXEC
Command History
clear cable modem {mac-addr | ip-addr | cable slot/port {all | oui string | reject} } counters
clear cable modem {mac-addr | ip-addr | cable slot/subslot/port {all | oui string | reject} }
counters
mac-addr Specifies the 48-bit hardware address (MAC address) of an individual
CM.
ip-addr Specifies the IP address of an individual CM.
cable slot/port Identifies the a interface and downstream port on the Cisco uBR7100
series and Cisco uBR7200 series routers.
On the Cisco uBR7100 series router, the only valid value is 1/0. On the
Cisco uBR7200 series router, slot can range from 3 to 6, and port can
be 0 or 1, depending on the cable interface.
cable slot/subslot/port Identifies a cable interface on the Cisco uBR10012 router. The
following are the valid values:
slot = 5 to 8
subslot = 0 or 1
port = 0 to 4 (depending on the cable interface)
all Resets the flapping counters for all CMs.
oui string Resets the flapping counters for all CMs that match the specified
Organization Unique Identifier (OUI). The string parameter can be
either the three byte hexadecimal string (such as 00.00.0C) or a vendor
name that has been defined using the cable modem vendor command.
reject Resets the flapping counters for all CMs that are currently in one of the
reject states (see the description of these states in the show cable
modem command).
Release Modification
12.1 T This command was introduced.
12.2(11)BC2 Support was added for the oui and reject options.
12.2(11)BC3 Support for clearing the counters for a particular cable interface was added.
OL-1581-05