27.03.2013 Views

Cisco Broadband Cable Command Reference Guide

Cisco Broadband Cable Command Reference Guide

Cisco Broadband Cable Command Reference Guide

SHOW MORE
SHOW LESS

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

hw-module slot pos<br />

hw-module slot pos<br />

Syntax Description<br />

3-20<br />

<strong>Cisco</strong> <strong>Broadband</strong> <strong>Cable</strong> <strong>Command</strong> <strong>Reference</strong> <strong>Guide</strong><br />

Chapter 3 <strong>Command</strong>s for the <strong>Cisco</strong> uBR10012 Router<br />

To configure a line card slot for Packet over SONET (POS) operation, use the hw-module slot pos<br />

command in privileged EXEC mode. To remove the configuration for a line card slot, use the no form<br />

of this command.<br />

hw-module slot slot-number pos<br />

no hw-module slot slot-number pos<br />

Defaults No default behavior or values<br />

<strong>Command</strong> Modes Privileged EXEC<br />

<strong>Command</strong> History<br />

slot slot-number Resets the line cards that are physically present in the specified slot-number<br />

(valid range is 1 to 8).<br />

Release Modification<br />

12.2(11)BC3 This command was introduced for the <strong>Cisco</strong> uBR10012 OC-48 Dynamic<br />

Packet Transport (DPT) Interface Module for the <strong>Cisco</strong> uBR10012 router.<br />

Usage <strong>Guide</strong>lines You must first use the hw-module slot pos command to preconfigure a line card slot for POS operation<br />

of the <strong>Cisco</strong> uBR10012 OC-48 DPT card before you can configure the card with any further commands.<br />

You must also use the card 1oc48dpt/pos-1 command to configure the card slot for the proper card type.<br />

Note If you have previously used the hw-module slot srp command to configure line card slots for Spatial<br />

Reuse Protocol (SRP) operation, you must first cancel that configuration using the no hw-module slot<br />

srp command before you can configure the slots for POS operation using the hw-module slot pos<br />

command.<br />

Examples The following example shows the <strong>Cisco</strong> uBR10012 OC-48 DPT line card in slot 3 being configured for<br />

POS operation:<br />

Router# hw-module slot 3 pos<br />

Router# card 3/0 1oc48dpt/pos-1<br />

The following example shows the <strong>Cisco</strong> uBR10012 OC-48 DPT line cards in slots 3 and 4 being<br />

reconfigured from SRP operation to POS operation:<br />

Router# no hw-module slot 3 srp<br />

Router# no hw-module slot 4 srp<br />

Router# hw-module slot 3 pos<br />

Router# card 3/0 1oc48dpt/pos-1<br />

Router# hw-module slot 4 pos<br />

OL-1581-05

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!