Cisco Broadband Cable Command Reference Guide

Chapter 5 Cable CPE Commands
show crypto engine configuration
OL-1581-05
show crypto engine configuration
To display the configuration information for the router’s onboard hardware accelerator engine, use the
show crypto engine configuration command in privileged EXEC mode.
Cisco uBR905, uBR925 cable access routers
show crypto engine configuration
Syntax Description This command has no arguments or keywords.
Command Modes Privileged EXEC
Command History
Release Modification
11.2 This command was introduced for the Cisco 7200, RSP7000, and
7500 series routers.
12.1(3)XL Support was added for the Cisco uBR905 cable access router.
12.2(2)XA Support was added for the Cisco uBR925 cable access router.
Usage Guidelines This command displays the version, capabilities, and other information for the hardware accelerator
engine that performs IPSec encryption/decryption for the router.
Examples The following example shows typical output from the show crypto engine configuration command:
Router# show crypto engine configuration
crypto engine name: unknown
crypto engine type: ISA/ISM
hifn chip id: 8
hifn rev : 0
hifn api rev: 0.22.0
Compression: No
3 DES: Yes
Privileged Mode: 0x0000
Maximum buffer length: 4096
Maximum DH index: 0010
Maximum SA index: 0020
Maximum Flow index: 0040
Maximum RSA key size: 0256
Crypto Adjacency Counts:
Lock Count: 0
Unlock Count: 0
Router#
Table 5-18 describes the fields shown in this display.
Cisco Broadband Cable Command Reference Guide
5-137