Cisco Broadband Cable Command Reference Guide

clear crypto ipsec client ezvpn
clear crypto ipsec client ezvpn
Syntax Description
5-24
Cisco Broadband Cable Command Reference Guide
Chapter 5 Cable CPE Commands
To reset the Cisco Easy VPN Remote state machine and bring down the Cisco Easy VPN Remote
connection on all interfaces or on a given interface (tunnel), use the clear crypto ipsec client ezvpn
command in privileged EXEC mode. If a tunnel name is specified, only the specified tunnel is cleared.
clear crypto ipsec client ezvpn [name]
Defaults If no tunnel name is specified, all active tunnels on the machine are cleared.
Command Modes Privileged EXEC
Command History
name (Optional) Identifies the IPSec VPN tunnel that is to be disconnected or
cleared with a unique, arbitrary name. If no name is specified, then all
existing tunnels are disconnected or cleared.
Release Modification
12.2(4)YA This command was introduced for Cisco 806, Cisco 826, Cisco 827, and
Cisco 828 routers; Cisco 1700 series routers; and Cisco uBR905 and
Cisco uBR925 cable access routers.
12.2(8)YJ The name option was added to to specify a particular IPSec VPN tunnel to
be cleared or disconnected.
Usage Guidelines The clear crypto ipsec client ezvpn command resets the Cisco Easy VPN Remote state machine,
bringing down the current Cisco Easy VPN Remote connection and bringing it back up on the interface.
If you specify a tunnel name, then only that tunnel is cleared. If no tunnel name is specified, all active
tunnels on the machine are cleared.
If the Cisco Easy VPN Remote connection for a particular interface is configured for autoconnect, this
command also initiates a new Cisco Easy VPN Remote connection.
Examples The following example shows the Cisco Easy VPN Remote state machine being reset:
Router# clear crypto ipsec client ezvpn
Router#
OL-1581-05