Cisco Broadband Cable Command Reference Guide

show hardware pxf cable
Related Commands
3-40
50.1.1.3 Cable5/0/0 0 0 1
50.1.1.29 Cable5/0/0 0 0 2
50.1.1.32 Cable5/0/0 0 0 2
50.1.2.6 Cable8/0/0 0 6 1
50.1.2.19 Cable8/0/0 0 6 1
Router#
Cisco Broadband Cable Command Reference Guide
Chapter 3 Commands for the Cisco uBR10012 Router
Table 3-4 describes the fields shown by the show hardware pxf cable source-verify command:
Table 3-4 show hardware pxf cable source-verify Field Descriptions
Field Description
IP Address Identifies the IP addresses that have been verified by the source-verify
feature.
Interface Identifies the cable interface or subinterface used for this IP address.
FIB Index Identifies the forwarding information base (FIB) being used.
Mac-Domain Identifies the MAC DOCSIS downstream domain for this IP address.
SID Identifies the service ID (SID).
Command Description
cable source-verify Enables verification of IP addresses for CMs and CPE devices on the
upstream.
clear pxf Clears the direct memory access (DMA) and error checking and correcting
(ECC) error counters on the PXF processor.
debug pxf Enables debugging of the PXF subsystems on the active PRE1 module on
the Cisco uBR10012 router.
show hardware pxf
cable interface
show hardware pxf
cpu
show hardware pxf
microcode
show hardware pxf
xcm
Displays display DOCSIS-related information about a particular service ID
(SID) on a particular cable interface.
Displays the display different statistics about the operation of the CPU
processor during PXF processing.
Displays identifying information for the microcode being used on the
processor.
Displays the current state of error checking and correcting (ECC) for the
External Column Memory (XCM) on the PXF processor.
OL-1581-05