Cisco Broadband Cable Command Reference Guide

show cable modem remote-query
show cable modem remote-query
2-378
Cisco Broadband Cable Command Reference Guide
Chapter 2 Cisco Cable Modem Termination System Commands
To display information collected by the remote-query feature, use the show cable modem remote-query
command in privileged EXEC mode.
show cable modem remote-query
Syntax Description This command has no keywords or arguments.
Command Modes Privileged EXEC
Command History
Release Modification
12.0(7)XR, 12.1(2)T This command was introduced.
12.1(2)EC1 Support for this command was added to the 12.1 EC train.
12.2(4)BC1b Support for this command was added to the 12.2 BC train.
Usage Guidelines This command shows the statistics collected when the remote-query feature has been enabled and
configured by the cable modem remote-query command.
Note In Cisco IOS Release 12.1 CX, Cisco IOS Release 12.2 BC, and later, the phy option should be
used instead of the remote-query option.
Tip The information shown by this command can also be displayed by querying the attributes in the
CISCO-DOCS-REMOTE-QUERY-MIB.
Examples The following example shows typical output from the show cable modem remote-query command. In
this example, the final CM (IP address of 10.200.71.2) has not been configured with an SNMP
community string that allows access to the remote-query feature.
Router# show cable modem remote-query
Remote Query Polling State : Active
IP address MAC address S/N US DS Tx Time Micro (dB) Modem
Ratio Power Power Offset Reflection State
10.200.71.8 0001.9659.47af 36.6 31.0 0.0 12352 17 online
10.200.71.4 0001.9659.47c7 36.6 37.0 0.0 12352 17 online
10.200.71.6 0001.9611.b9a3 36.6 37.0 0.0 12353 15 online
10.200.71.3 0001.9659.47a9 36.6 37.0 0.0 12351 16 online
10.200.71.2 0001.9659.47c1 0.0 0.0 0.0 0 0 online
Router#
Table 2-23 shows the fields displayed by the show cable modem remote-query command.
OL-1581-05