Cisco Broadband Cable Command Reference Guide

show interface cable modem
show interface cable modem
Syntax Description
Command Modes Privileged EXEC
Command History
2-438
Cisco Broadband Cable Command Reference Guide
Chapter 2 Cisco Cable Modem Termination System Commands
To display information about the CMs connected to a particular cable interface, use the show interface
cable modem command in privileged EXEC mode.
show interface cable {slot/port | slot/subslot/port} modem [sid]
slot/port Identifies the cable interface and downstream port on the Cisco uBR7100 series
and Cisco uBR7200 series routers.
On the Cisco uBR7100 series router, the only valid value is 1/0. On the
Cisco uBR7200 series router, slot can range from 3 to 6, and port can be 0 or 1,
depending on the cable interface.
slot/subslot/port Identifies the cable interface on the Cisco uBR10012 router. The following are
the valid values:
Examples The following is sample output from the show interface cable modem command for all SIDs on a
particular cable interface.
Router# show interface cable 6/0 modem
SID Priv bits Type State IP address method MAC address
1 11 modem online(pt) 1.2.3.2 dhcp 0050.7366.1837
2 11 modem online(pt) 1.2.3.3 dhcp 0010.7b6b.71fd
3 11 modem online(pt) 1.2.3.4 dhcp 0010.7bb3.fc3d
4 00 modem init(r1) 1.2.3.238 dhcp 0010.7b6b.71a9
5 11 modem online(pt) 1.2.3.5 dhcp 0010.7bed.a731
6 11 modem online(pt) 1.2.3.20 dhcp 0010.7bed.ab4b
7 11 modem online(pt) 1.2.3.18 dhcp 0010.7b6b.71e3
8 11 modem online(pt) 1.2.3.13 dhcp 0010.7bed.ab6f
9 11 modem online(pt) 1.2.3.21 dhcp 0010.7bed.a52f
10 11 modem online(pt) 1.2.3.14 dhcp 0010.7b6b.7191
11 11 modem online(pt) 1.2.3.6 dhcp 0010.7bed.ab57
Router#
slot = 5 to 8
subslot = 0 or 1
port = 0 to 4 (depending on the cable interface)
sid (Optional) Specifies the service ID (SID) to be displayed (1 to 8191).
Release Modification
12.2(11)BC2 This command was officially supported for the Cisco uBR7100 series,
Cisco uBR7200 series, and Cisco uBR10012 routers.
OL-1581-05