27.03.2013 Views

Cisco Broadband Cable Command Reference Guide

Cisco Broadband Cable Command Reference Guide

Cisco Broadband Cable Command Reference Guide

SHOW MORE
SHOW LESS

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

Chapter 3 <strong>Command</strong>s for the <strong>Cisco</strong> uBR10012 Router<br />

OL-1581-05<br />

<strong>Cisco</strong> <strong>Broadband</strong> <strong>Cable</strong> <strong>Command</strong> <strong>Reference</strong> <strong>Guide</strong><br />

microcode reload<br />

00:49:41: Downloading Microcode: file=system:pxf/ubr10k-1-ucode.122.1.0, version=122.1.0,<br />

description=Release Software created Wed 17-Jul-02 16:58<br />

<br />

00:49:42: !!pxf clients started, forwarding code operational!!<br />

Router#<br />

The following example shows a typical list of devices that you can use when loading microcode for the<br />

PXF processors. This list might vary, depending on whether a standby PRE1 module is installed and<br />

depending on the version of <strong>Cisco</strong> IOS software being used.<br />

Router# microcode reload pxf ?<br />

bootflash: location of microcode<br />

disk0: location of microcode<br />

disk1: location of microcode<br />

flash: location of microcode<br />

ftp: location of microcode<br />

null: location of microcode<br />

nvram: location of microcode<br />

rcp: location of microcode<br />

scp: location of microcode<br />

sec-bootflash: location of microcode<br />

sec-disk0: location of microcode<br />

sec-disk1: location of microcode<br />

sec-nvram: location of microcode<br />

sec-slot0: location of microcode<br />

sec-slot1: location of microcode<br />

slot0: location of microcode<br />

slot1: location of microcode<br />

system: location of microcode<br />

tftp: location of microcode<br />

<br />

Router#<br />

The following example shows how to reload the microcode on the PXF processors on the PRE1 module,<br />

using a specific image that is stored in the Flash memory:<br />

Router# microcode reload pxf flash:pxf/ubr10k-1-ucode.122.1.0.4<br />

Reload microcode? [confirm] yes<br />

3d00h: Downloading Microcode: file=flash:pxf/ubr10k-1-ucode.122.1.0.4, version=122.1.0.4,<br />

description=Release Software created Thu 27-Jun-02 16:05<br />

<br />

3d00h: !!pxf clients started, forwarding code operational!!<br />

Router#<br />

Related <strong>Command</strong>s <strong>Command</strong> Description<br />

hw-module reset Resets a particular PRE1 module or a particular line card.<br />

microcode Reloads the microcode software images on one or all line cards that support<br />

downloadable microcode.<br />

show hardware pxf Displays display identifying information for the microcode being used on<br />

microcode<br />

the PXF processors.<br />

3-29

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!