Cisco Broadband Cable Command Reference Guide

debug cable flap
debug cable flap
4-26
Cisco Broadband Cable Command Reference Guide
Chapter 4 Cisco Cable Modem Termination System Debugging Commands
To display information about the operation of the CM flap list that is maintained for the cable interfaces,
use the debug cable flap command in Privileged EXEC mode. To disable debugging output, use the no
form of this command.
debug cable flap
no debug cable flap
Syntax Description This command has no arguments or keywords.
Defaults No default behavior or values.
Command Modes Privileged EXEC
Command History
Release Modification
11.3(8)NA, 12.0(4)T This command was introduced for Cisco uBR7200 series routers.
12.0(6)SC Support for this command was added to the Release 12.0 SC train.
12.1(5)EC Support for this command was added for the Cisco uBR7100 series
routers.
12.2(4)BC1 Support was added to the Release 12.2 BC train.
12.2(11)BC2 Support for this command was added to the Release 12.2 BC train.
Usage Guidelines This command shows debugging messages about the internal configuration file editor on the Cisco
CMTS. For more information about the internal configuration file editor, see the cable config-file
command and its subcommands.
Caution The debug commands are primarily intended for use in controlled test and troubleshooting situations
with a limited volume of traffic.
Examples The following example shows how to enable debugging for the internal configuration file editor:
Router# debug cable flap
CMTS flap debugging is on
Router# show debug
CMTS:
CMTS flap debugging is on
Router#
OL-1581-05