Cisco Broadband Cable Command Reference Guide

hccp channel-switch
hccp channel-switch
2-290
Cisco Broadband Cable Command Reference Guide
Chapter 2 Cisco Cable Modem Termination System Commands
To configure the Cisco CMTS so that a Cisco uBR-RFSW N+1 RF Switch, Quintech RF switch, or
Wavecom upconverter becomes part of the specified HCCP member in a particular HCCP group, use the
hccp channel-switch command in cable interface configuration mode. To remove the configuration for
the RF switch or upconverter, use the no form of this command.
hccp group channel-switch member-id switch-name rfswitch-group rfswitch-ip-address
module-bitmap position
hccp group channel-switch member-id switch-name rfswitch-module rfswitch-ip-address
module-number position
hccp group channel-switch member-id switch-name tty-switch [aux | console | vty] line-number
port
hccp group channel-switch member-id switch-name {wavecom-hd | wavecom-ma}
prot-ip-address protect-module work-ip-address work-module
no hccp group channel-switch member-id switch-name
Syntax Description group The group number for the specified interface. The valid range is 1 to 255.
member-id The member number within the specified group. The valid range is 1 to 255.
switch-name Specifies the name of the switchover group that has been configured on the
Cisco RF Switch using the set switchover-group command.
rfswitch-group Specifies that this is the configuration for an Cisco uBR-RFSW N+1 RF
Switch group.
rfswitch-module Specifies that this is the configuration for an Cisco uBR-RFSW N+1 RF
Switch module.
rfswitch-ip-address Specifies the IP address of the RF switch to which the CMTS is connected.
module-bitmap Specifies the module-bitmap in hexadecimal. The valid range is 0 to
FFFFFFFF.
Tip See the TAC-authored N+1 Tips and Configuration document on
Cisco.com for more information on the format of the bitmap, and
for a worksheet that can be used to calculate the bitmap.
module-number Specifies the module number on the Cisco uBR-RFSW N+1 RF Switch. The
valid range is 1 to 255.
position Specifies the position for the Working channel on the Cisco uBR-RFSW
N+1 RF Switch. The valid range is 1 to 8.
tty-switch Specifies the configuration of a Quintech RF switch that is controlled by its
TTY line. You can further specify the type of port being used to control the
switch. By default, one of the switch’s serial ports is used, or you can use
the aux, console, or vty lines.
Note Ensure that the switch’s DIP switch is set to 00.
aux (Optional) Specifies that the auxiliary port is being used to control the
Quintech RF switch.
console (Optional) Specifies that the console port is being used to control the
Quintech RF switch.
OL-1581-05