Cisco Broadband Cable Command Reference Guide

Chapter 5 Cable CPE Commands
debug cable-modem interrupts
OL-1581-05
debug cable-modem interrupts
To display information about cable interface interrupts, use the debug cable-modem interrupts
command in privileged EXEC mode. To turn off cable interface interrupt debugging, use the no form of
this command.
Cisco uBR904, uBR905, uBR924, uBR925 cable access routers, Cisco CVA122 Cable Voice Adapter
debug cable-modem interrupts
no debug cable-modem interrupts
Syntax Description This command has no arguments or keywords.
Command Modes Privileged EXEC
Command History
Release Modification
11.3(4)NA This command was introduced for the Cisco uBR904 cable access router.
12.0(4)XI1 Support was added for the Cisco uBR924 cable access router.
12.0(5), 12.0(5)T This command was removed from normal access.
Usage Guidelines In Cisco IOS Release 12.0(5) and later releases, this command is available only under the direction of
TAC or field service, and should be used only while debugging CM operation. Displaying debugging
messages consumes system resources, and turning on too many messages could negatively affect system
performance.
Examples The following shows typical output for the debug cable-modem interrupts command:
Router# debug cable-modem interrupts
Router#
*** bcm3220_rx_mac_msg_interrupt ***
*** bcm3220_rx_mac_msg_interrupt ***
### bcm3220_tx_interrupt ###
*** bcm3220_rx_mac_msg_interrupt ***
### bcm3220_tx_interrupt ###
*** bcm3220_rx_mac_msg_interrupt ***
### bcm3220_tx_interrupt ###
### bcm3220_tx_interrupt ###
### bcm3220_tx_interrupt ###
### bcm3220_tx_interrupt ###
Cisco Broadband Cable Command Reference Guide
5-175