27.03.2013 Views

Cisco Broadband Cable Command Reference Guide

Cisco Broadband Cable Command Reference Guide

Cisco Broadband Cable Command Reference Guide

SHOW MORE
SHOW LESS

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

show controllers cable-modem des<br />

Related <strong>Command</strong>s<br />

5-84<br />

pb_req_bytes_to_minislots=0x10<br />

us_des_ctrl=0x00, us_des_sid_1= 0x1234<br />

ds_unencrypted_length=0x0C<br />

Router#<br />

<strong>Cisco</strong> <strong>Broadband</strong> <strong>Cable</strong> <strong>Command</strong> <strong>Reference</strong> <strong>Guide</strong><br />

Chapter 5 <strong>Cable</strong> CPE <strong>Command</strong>s<br />

Table 5-8 describes the significant fields shown in the display. For more information, see the Broadcom<br />

documentation for the BCM3300 chip.<br />

Table 5-8 show controllers cable-modem des Field Descriptions<br />

Field Description<br />

ds_des_key_table Displays a table showing the downstream DES keys.<br />

ds_des_cbc_iv_table Displays a table showing the downstream DES Cipher Block Chaining<br />

(CBC) mode information.<br />

ds_des_sid_table Displays a table showing the SID values to be enabled for DES encryption.<br />

ds_des_sid_enable Identifies which SID entries in the SID table are enabled for encryption. In<br />

the above example, none of the entries are enabled for encryption.<br />

ds_des_ctrl Control register that identifies the operating mode of the downstream DES<br />

engine.<br />

ds_des_sv Displays the DES security version register; the range of the version field in<br />

the Baseline Privacy Interface (BPI) extended headers that will be accepted<br />

by the hardware. High byte is upper limit, low byte is lower limit. The router<br />

will accept versions 0 to 15.<br />

ds_unencrypted_length Specifies the number of bytes that will be unencrypted at the beginning of<br />

the MAC frame. 0x0C means the first 12 bytes are not encrypted, which is<br />

what the DOCSIS Baseline Privacy specification calls for.<br />

us_des_key_table Displays a table showing upstream DES keys.<br />

us_des_cbc_iv_table Displays a table of upstream DES CBC mode information.<br />

us_des_ctrl Control register that controls the operating mode of the upstream DES<br />

engine. The value 0x24 means that the upstream is configured to enable<br />

decryption and to use CBC mode.<br />

Tip In <strong>Cisco</strong> IOS Release 12.2(8)T and later releases, you can add a timestamp to show commands using the<br />

exec prompt timestamp command in line configuration mode.<br />

<strong>Command</strong> Description<br />

show controllers cable-modem Displays high-level controller information about the cable interface.<br />

show controllers cable-modem Displays information about the baseline privacy key management<br />

bpkm<br />

exchange between the cable interface and the CMTS.<br />

show controllers cable-modem Displays the registers in the MAC hardware that are used for<br />

filters<br />

filtering received frames.<br />

show controllers cable-modem<br />

lookup-table<br />

Displays the mini-slot lookup table for the cable interface.<br />

show controllers cable-modem<br />

mac<br />

Displays detailed MAC-layer information for the cable interface.<br />

OL-1581-05

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!