Cisco Broadband Cable Command Reference Guide

Chapter 5 Cable CPE Commands
interface cable-modem
Syntax Description
Defaults Disabled
OL-1581-05
Cisco Broadband Cable Command Reference Guide
interface cable-modem
To enter interface configuration mode for the cable interface on a router, use the interface cable-modem
command in global configuration mode.
Cisco uBR904, uBR905, uBR924, uBR925 cable access routers, Cisco CVA122 Cable Voice Adapter
interface cable-modem number
Command Modes Global configuration
Command History
Usage Guidelines When this command is entered, the router switches from global configuration mode to interface
configuration mode.
Examples The following example shows how to enter interface configuration mode for the router’s cable interface
and then to enter the available interface configuration commands:
Related Commands
number Identifies the cable interface (always 0).
Release Modification
11.3(4)NA This command was introduced for the Cisco uBR904 cable access router.
12.0(4)XI1 Support was added for the Cisco uBR924 cable access router.
12.1(3)XL Support was added for the Cisco uBR905 cable access router.
12.1(5)XU1 Support was added for the Cisco CVA122 Cable Voice Adapter.
12.2(2)XA Support was added for the Cisco uBR925 cable access router.
Router(config)# interface cable-modem 0
Router(config-if)# cable-modem ?
compliant Enter compliant modes for interface
downstream Downstream channel characteristics
fast-search Enable/disable the DS fast search
upstream upstream channel characteristics
voip Options for Voice over IP traffic over the cable interface
Router(config-if)#
Command Description
cable-modem compliant bridge Enables DOCSIS-compliant bridging on the cable interface.
cable-modem downstream Modifies the saved downstream channel setting and upstream power
saved channel
value on the cable interface.
5-49