Cisco Broadband Cable Command Reference Guide

Chapter 5 Cable CPE Commands
show interfaces usb
Syntax Description:
Command Modes Privileged EXEC
Command History
OL-1581-05
Cisco Broadband Cable Command Reference Guide
show interfaces usb
To display configuration information about the USB interface, use the show interfaces usb command in
privileged EXEC mode.
Cisco uBR925 cable access router, Cisco CVA122 Cable Voice Adapter
show interfaces usb number
number Identifies the USB interface (always 0).
Release Modification
12.1(5)XU1 This command was introduced for the Cisco CVA122 Cable Voice Adapter.
12.2(2)XA Support was added for the Cisco uBR925 cable access router.
Examples The following shows typical output from the show interfaces usb command:
Router# show interface usb0
USB0 is up, line protocol is down
Hardware is M850_USB, address is 0001.64f9.22fe (bia 0001.64f9.22fe)
Internet address is 192.168.100.1/24
MTU 1500 bytes, BW 12000 Kbit, DLY 1000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
ARP type:ARPA, ARP Timeout 00:00:00
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Queueing strategy:fifo
Output queue 0/40, 0 drops; input queue 0/75, 0 drops
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
2 packets output, 120 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
Router#
Tip In Cisco IOS Release 12.2(8)T and later releases, you can add a timestamp to show commands using the
exec prompt timestamp command in line configuration mode.
5-157