Cisco Broadband Cable Command Reference Guide

show cable qos permission
show cable qos permission
2-386
Cisco Broadband Cable Command Reference Guide
Chapter 2 Cisco Cable Modem Termination System Commands
To display the status of permissions for changing quality-of-service (QoS) tables on a Cisco CMTS, use
the show cable qos permission command in privileged EXEC mode.
show cable qos permission
Syntax Description This command has no keywords or arguments.
Command Modes Privileged EXEC
Command History
Release Modification
12.1 T This command was introduced.
12.1(4)CX This command was deprecated for DOCSIS 1.1 use, because DOCSIS 1.1
replaces the QoS profile model with a service flow model. The show
interface cable qos paramset command is used for DOCSIS 1.1 operation.
Examples The following example displays the output of the show cable qos permission command:
CMTS01# show cable qos permission
Create by SNMP Update by SNMP Create by modems
yes yes yes
Table 2-25 describes the fields displayed by the show cable qos permission command.
Table 2-25 show cable qos permission Command Field Descriptions
Field Description
Create by SNMP Indicates permission setting for creation of QoS table entries by the
Simple Network Management Protocol (SNMP).
Update by SNMP Indicates permission setting for creation of QoS table entries by
modem registration requests.
Create by modems Indicates permission setting for dynamic updating of QoS table
entries by the SNMP.
Tip In Cisco IOS Release 12.1(12)EC, 12.2(8)BC1, and later releases, you can add a timestamp to show
commands using the exec prompt timestamp command in line configuration mode.
OL-1581-05