Cisco Broadband Cable Command Reference Guide

show diag
show diag
Syntax Description
2-416
Cisco Broadband Cable Command Reference Guide
Chapter 2 Cisco Cable Modem Termination System Commands
To display the revision-level information for a Cisco CMTS cable interface, use the show diag command
in privileged EXEC mode.
show diag [slot]
Command Modes Privileged EXEC
Command History
slot (Optional) Identifies the Cisco CMTS chassis slot number to be
displayed.
Release Modification
11.1 CA This command was introduced.
11.2 P This command was modified to update the sample display for the port
adapters PA-12E/2FE, PA-E3, and PA-T3.
11.3 XA This command was made available for Cisco IOS Release 11.3 XA.
12.0(5)XQ This command was enhanced and made available for the Cisco 1750 router.
12.1(1a)T1 This command was modified to include information about the cable clock
card.
Usage Guidelines This command displays information for the electrically erasable programmable read-only memory
(EEPROM), the motherboard, and the WAN interface cards (WICs) and voice interface cards
(VICs).This command also displays information about the cable clock card, if installed.
Examples The following is sample output from the show diag command displaying diagnostic information for the
cable clock card:
router# show diag
Clockcard:
National clock card with T1 controller
EEPROM contents at hardware discovery:
Hardware Revision :1.1
Part Number :800-05867-02
Board Revision :11
Deviation Number :0-0
Fab Version :02
PCB Serial Number :CAB04046NXV
RMA Test History :00
RMA Number :0-0-0-0
RMA History :00
EEPROM format version 4
EEPROM contents (hex):
0x00:04 FF 40 01 AC 41 01 01 C0 46 03 20 00 16 EB 02
0x10:42 31 31 80 00 00 00 00 02 02 C1 8B 43 41 42 30
0x20:34 30 34 36 4E 58 56 03 00 81 00 00 00 00 04 00
OL-1581-05