Cisco Broadband Cable Command Reference Guide

show controllers cable-modem qos
5-118
Cisco Broadband Cable Command Reference Guide
Chapter 5 Cable CPE Commands
Table 5-14 show controllers cable-modem qos Field Descriptions (DOCSIS 1.1) (continued)
Field Description
valid A 13-bit bitmask showing which Type/Length/Value (TLV) fields were set
on the classifier. The following shows the meaning of each bit, with the
least significant bit on the far right. The bit is set to 1 if the corresponding
TLV was set for the classifier:
0x0001—IP Type of Service Range and Mask
0x0002—IP Protocol
0x0004—IP Source Address
0x0008—IP Source Mask
0x0010—IP Destination Address
0x0020—IP Destination Mask
0x0040—TCP/UDP Source Port Start and TCP/UDP Source Port End
0x0080—TCP/UDP Destination Port Start and TCP/UDP Destination
Port End
0x0100—Destination MAC Address
0x0200—Source MAC Address
0x0400—Ethertype/DSAP/MacType
0x0800—IEEE 802.1P User_Priority
0x1000—IEEE 802.1Q VLAN_ID
For example, a value of D6 translates to the bit-mask “1101 0110”, which
indicates that the following fields were set for the classifier: IP Protocol,
IP Source Address, IP Destination Address, and the TCP/UDP Source and
Destination Port values.
Match Number of packets matching the classifier.
SIDT Address for the classifier in the internal SID table (SIDT).
Packet Classifier Details Describes each packet classifier in detail.
Classifier ID ID used to uniquely identify the classifier in each service flow.
SFID ID that uniquely identifies the service flow.
IP source The matching IP source address.
IP dest The matching IP destination address.
UDP/TCP source range The low-end and high-end matching source TCP/UDP port values.
UDP/TCP dest range The low-end and high-end matching destination TCP/UDP port values.
IP Protocol The matching IP protocol type, as given in RFC 1700. A value of 256
matches any IP protocol, and a value of 257 matches TCP and UDP traffic.
PHS Indicates whether Payload Header Suppression (PHS) is active or inactive.
Downstream Payload Indicates that PHS is being used on the downstream.
Header Suppression
OL-1581-05