Cisco Broadband Cable Command Reference Guide

show hardware pxf cpu command 3-44
show hardware pxf dma command 3-60
show hardware pxf microcode command 3-67
show hardware pxf xcm command 3-70
show hccp command 2-420
show hccp interface command 2-425
show interface cable command 2-427
show interface cable downstream command 2-432
show interface cable intercept command 2-434
show interface cable mac-scheduler command 2-436
show interface cable modem command 2-438
show interface cable monitor command 2-441
show interface cable qos paramset command 2-445
show interface cable service-flow command 2-447
show interface cable sid command 2-452
show interface cable signal-quality command 2-459
show interface cable upstream command 2-461
show interfaces cable-modem command 5-150
show interfaces usb command 5-157
show packetcable global command 2-470
show processor cpu command 3-50
show redundancy command 3-73
show tech-support command 2-473
show version command 2-476
show voice port command 5-162
sniffing packets on the cable interface
SNMP
2-110
enabling cable-related traps 2-480, 2-482
enabling cable traps 2-480
enabling CM state change traps 2-59
enabling DOCSIS traps 2-482
polling CMs 2-103
setting default values for the Subscriber Management
MIB 2-164
specifying a manager in the DOCSIS configuration
file 2-478
snmp manager command 2-478
snmp-server enable cable command 2-480, 2-482
snmp-server enable traps cable command 2-480
OL-1581-05
Cisco Broadband Cable Command Reference Guide
Index
snmp-server enable traps docsis-cmts command 2-482
specifying the maximum number of hosts
spectrum group
2-91
configuring shared spectrum groups 2-162
configuring the hop period 2-157
configuring the hop threshold value 2-159
creating 2-151, 2-155, 2-245
debugging 4-29
displaying 2-394, 2-406
switchover command 3-77
T
T9 timer, setting
TCC+ card
2-131
clearing clock counters 2-20
displaying clock reference information 2-410
displaying clock reference status 2-347
displaying TDM clock reference 2-419
selecting external timing source 2-22
setting midplane clock reference 2-24
TEK, setting values
telco-return
2-123
enabling 2-169
enabling DHCP server 2-175
setting for manual-dial mode 2-183
setting the authentication method 2-189
setting the authentication password 2-185
setting the authentication username 2-197
setting the default SPD value 2-181
setting the idle timeout value 2-179
setting the RADIUS server 2-191
setting the registration IP addresses 2-173
setting the service provider name 2-193
setting the TCD/TSI intervals 2-171
setting the telephone numbers for headend access 2-187
setting the threshold for dial-up failures 2-195
specifying the IP address for the DHCP server 2-177
temperature thresholds, setting facility alarms 3-13
IN-9